Recent content by Ed Valvo

I dig the crankcase breather tapped in the valve cover which got me thinking.... with a ton of us running VC breathers, does anyone vendors sell a crankcase breather setup? I like the tapped plate in the side of the front cover. Access would be a PITA though...

Some of the original pics are not working in this thread due to age however I get the idea and I am interested in the block off plate with tapped vent in the front cover. Do any vendors sell this? I like this idea if it works.

I guess I could try a set and see. Almost did the other day until I saw the prices. LOL Reading the stuff above, I did have fouling issues running race plugs like the Autolite non resistor type AR3933. Ran ok (not better or faster) when first installed but the next couple drives really...

Anyone driving around on the street with success on Brisk plugs? Or just racing? Concerned about fouling issues so Im looking at the DR14s.

Works great. Only issue is top bolt is threaded.

Is there and difference in the seat? Can you swap a non power seat on to a power seat base/track?

3 of us are coming from CA. Not racing though. Work and life got in the way, not to mention a hell of a long haul, so we're just spectating. Sucks too because my car is running great....

C16.

135 mph in the 1/4 on gas, no alky, with a Walbro F90000267 450LPH purchased from Full Throttle. Fuel line upgrade and hot wire kit was necessary.

I picked up 2 mph in the 1/4 mile with the Big Mouth Kit from Mark H.

Anyone got a spare?

PM received.

I'll take it.

Looks like it would hit the people sitting in the car...

Happens all the time. Good thing you caught it early.