Recent content by Dunebilly

  1. D

    Gen II powers up and works but will not allow selection of page or value

    I'll have to it doesn't do a thing. I have a powerlogger I was going to send you a while ago but I bought a second one first but still have this one can i send you both? What address do I send them to
  2. D

    Gen II powers up and works but will not allow selection of page or value

    I followed these reset instructions ....no effect do I need to flash my translator? It says it's very 1.35 when I start up
  3. D

    Gen II powers up and works but will not allow selection of page or value

    It's frustrating to see its reading voltage and rpms but will not let any buttons work
  4. D

    Gen II powers up and works but will not allow selection of page or value

    I Tried both with no luck. Is there any other way to factory reset the Gen 2
  5. D

    Gen II powers up and works but will not allow selection of page or value

    Thanks I wanted to find the factory reset steps
  6. D

    Gen II powers up and works but will not allow selection of page or value

    My translator has always worked fine and when I start the car everything powers up but the translator won't change value it just shows battery voltage and rpm as it would but that's all
  7. D

    First G-body build, Turbo LS1 in an 87 Regal Limited

    great build thread~! I'm planning on doing this to my green regal limited I grabbed for the very same reason. I have my T type with the turbo 3.8 I'll be keeping that one real. this ones under the knife
  8. D

    UMI a arms giving too much camber

    My next thing is cooking my 2002 LS brake set up with 12 inch rotors on to the spindles I don't have the right adapter relocation bracket but I will either I will either buy one or make one
  9. D

    UMI a arms giving too much camber

    I just put on beltech drop spindles(98-2005) I was able to raise the shock and currency or alot
  10. D

    UMI a arms giving too much camber

    I have 4 shims in the front and 2 in the back and its still wack I'm thinking tall lowers are what I should do
  11. D

    Tall ball joints

    if you use tall uppers should you get the lower ones ?
  12. D

    UMI a arms giving too much camber

    Hi I am installing a arms with tall ball joints with coilovers on a regal chassis. I am trying to lower the front but the camber is way too positive I have stock spindles and the lower ball joints that came on the lower arms are short. what would bee the best way to make things correct and...
  13. D

    racegate install question

    hi guys not to dig up and old time thread but if I fab a dump tube from my racegate outlet down to where my exhaust starts under the car does that affect any of my readings if it is after my wideband sensor? I have seen ones online but most were on stuff like supras here is a pic of what I mean
  14. D

    Ridetech G-Body "Tru-Turn" & Coil Over Install

    Thanks will do Posted from the TurboBuick.Com mobile app
Top