Recent content by brandnu6

  1. B

    Caution

    Hello everyone. F.Y.I. Want to pass something along. Almost a disaster! While removing alternator, had to remove "MAF pipe." That's when I discovered bottom side [not visible from above] had a deep groove cut into it. This was because of the radiator hose clamp that is fastened to long bolt that...
  2. B

    "Casper Electronics" led cam sensor cap

    Hello there. Thanks for getting back to me, again. I have no way of knowing what you are asking. In the interest of simplicity, rotating the cap one direction or another will effect when fuel is sprayed. What direction causes "early spray," and what would be the result? What direction causes...
  3. B

    "Casper Electronics" led cam sensor cap

    Hi. Is that all the information we have about "Casper's led cam sensor cap?" Come on guys, we can do better than that. Early spray, Late spray. Counter clockwise or Clockwise. Aftermarket "Comp Cam" 212/212 flat tappet? Talk to me...
  4. B

    "Casper Electronics" led cam sensor cap

    Thanks man.
  5. B

    "Casper Electronics" led cam sensor cap

    Hello out there. Changed "oil filter adapter" O/ring, was leaking. Got one from "Richard Clark." Different design, "Quad Ring" check It out. Also tightened "turbo drain hose" at the block. It was also lose and leaking. When I changed "O/ring," I lost suction at the "oil pump." So I pulled "cam...
  6. B

    "oil pan gasket"

    Thanks for the information...
  7. B

    "oil pan gasket"

    Hello everyone. What is the best choice regarding "oil pan gasket" material and brand? Thanks very much.
  8. B

    E85 with or without upgraded ECM ?

    Good morning all. So I seem to have run across a another issue with regard to converting over to E-85. The gas tank! Spectra 307C. The one designed for our cars. It has "dog dish" in the tank. It's there to keep the pump submerged in fuel. It is metal, unlike the oem baffles that were plastic...
  9. B

    E85 with or without upgraded ECM ?

    Hi there. This sure turned out to be quite a post. However, It seems to have dwarfed into an "Alky vs. E-85" conversation. I'm reading about running 30+lbs. of boost, not going there. Making 600+rwh HP, not going there either. Let me repeat, this car will never be at the track. I have a mild...
  10. B

    E85 with or without upgraded ECM ?

    Hello. What can I say? Thankyou. So, the reason I'm thinking E-85 [Ethanol.] vs. Alky [Methanol.] is that It Is less corrosive. Also people I've talked to about "Alky" wish they hadn't chose It. Maybe because It was the "best bang for your buck" at the time. Nowadays we have -85. Granted, It's...
  11. B

    E85 with or without upgraded ECM ?

    Hello everyone. Thankyou all for your opinions. I have given some thought to your responses. I did think of a few other upgrades, I do have a cam. 212/212 flat tappet [Comp Cams.] LT1 MAF with translator. Also "Tinman" 4" cold air intake down low, just below the front bumper. Now for the good...
  12. B

    E85 with or without upgraded ECM ?

    Hi Guys ,thanks for your input. As far as upgrades, all the popular ones. TA49 rebuilt. 3" down pipe, 3" test pipe, TA headers, Dutt. neck SLIC, 62mm throttle body [Steve Monroe], 42lb injectors w/ 93 oct. chip [Eric Marshall], lots of "Casper's electronics" wiring upgrades, Including fuel pump...
  13. B

    E85 with or without upgraded ECM ?

    Hello. Hope everyone is well / wearing a mask! Anyway.. I'm thinking of converting to E85. So I understand about having an adequate fuel pump {Racetronix/Walbro 340.} And larger fuel lines, {Teflon lined.} Got that. I know I have to increase the size of fuel injectors and E85 chip "Eric...
  14. B

    CAS V4 "middle size" 18 or 19 row

    Hi. Thanks for response. Sounds like It's not in mint condition. If you want to foward a couple of images, I'll take a look. Take care...
  15. B

    CAS V4 "middle size" 18 or 19 row

    Hello everyone . I'm still for old school stretch I.C. As always, condition will determine the price. Thanks.
Top