Recent content by azgn

oh, mid 9's at least.........at least until you hit the track

disconnect the wastegate arm from the puck.....you should have maybe 5 lbs of boost then start looking for what is wrong

bigger turbo, transbrake and 1.4x 60' times "may" get you mid-high 10's low 10's is a whloe 'nother bag of worms...... you'll need race gas and timing to go much farther than low 11's.....even Razor just barely gets into 10's with alky and TTA I would ignore those who haven't "been...

turn it up! shift it at 6500 min......think you'll like it! (launch it harder too....I typically leave at 15 lbs.......)

something is hooked up wrong/not working right as suggested, take off the RJC then connect wastegate to compressor with the gate loose.....this should lower the boost a non ported wastegate hole usually results in a spike, not uncontrolled boost

my car with the "N" stall Art Carr shows 6100 at 128 also (however, my et's are 10.4-10.5 at that speed).......if your launches are at least low 1.4x or better, converter is fine.....your shift points could also be raised to 6500-7000 no problem

ASSuming you have the WB 02, it will correct the AF ratio for you as you increase boost......you can then go back into the VE tables and zero the correction you can use the stock knock detector with FAST......however, if you are running a "noisy" valve train, not much use.....egt is helpful also

83's.....duty cycle in the low 80's at 130

that sure as hell isn't 800 hp........there is always an example of something that is difficult to do....that doesn't make it doable by everyone.....A GTQ is gonna make a bunch more power than a P trim

take Red Regal T's advice....shoot for mid 11's and stay there...particularly if it is your only car.......you'll have plenty of downtime at that power level

the so called "HP" ratings on turbos are BS....there is no PT67 that will make 800HP on a 3.8 litre motor......maybe on a 600 cu in V8, but I even sorta doubt that that size turbo is good for high 10's on a normal weight TR.....if everything else is up to the task...... (BTW, there is no...

11.96 is a long way away from 10.x....... to run 10's you'll need 60' in the 1.5 range and speeds around 122 sooooo, trans brake launch on slicks, race gas, and 30 lbs of boost (with 26* of timing) or so should do it....you'll start to run out of fuel at those speeds, so put a double...

I used the ATR and now the HR....my car 60's in the low 1.4's.....the difference between the two is dramatic......with the ATR, the car would twist a bunch and pull the drivers side wheel about three feet in the air....with the HR, no twist and would pull both front wheels just off the ground....

TE-45A....will be much harder on anything smaller

FYI, a "regular" THDP will NOT fit on ATR headers......they make one that will, but it is different