Recent content by airborne_rex

  1. A

    PBM Hydraulic Roller Lifters

    Lightly used PBM Hydraulic Roller Lifters about 2000 miles or less. Asking $250 plus 20 shipping.
  2. A

    Body Lift Points.

    I have the ability to lift it completely overhead. Is there a safe way to do this without damaging the body?
  3. A

    Body Lift Points.

    I have an 87 T-top GN what are the best lift points to remove the body off of the frame and other than the steering linkage and body mount bolts are there any other fasteners or parts holding the body to the frame? I should mention that I have a 10 ton over head bridge crane to do the lifting with.
  4. A

    Fuel Sending unit for Digital Dash.

    Looking for a good fuel sending unit hanger assembly for a digital dash car.
  5. A

    ISO Solid G-Body in DFW area.

    Looking for a solid G-body in the dallas fort worth area. engine or no engine doesn't matter. something with a solid frame and body.
  6. A

    Cylinder head bolt sealant

    Has anyone used Leak Lock from Highside Chemicals on their head bolts to seal them in the water jacket? I use this stuff regularly in the electric motor and generator industry. Seems to work well on fluids. The rep says it can be used with antifreeze and its rated up to 400 degrees F. Or anybody...
  7. A

    stalled then restarted fine....

    momentary block in the fuel system somewhere?
  8. A

    Knock Sensor info

    Does anyone know off hand what the thread pitch is on the knock sensor? Need to grab a tap to clean the hole in the block.
  9. A

    Head gasket size

    If my cylinders are bored .040 over stock then what size bore should my new head gaskets be?
  10. A

    Crank shaft journal sizes.

    Does anybody have information on what the main bearing journal and rod bearing journal sizes should be on a stock 87 crank?
  11. A

    Body off frame.

    I'm pulling my engine and trans out to clean up some leaks and replace the fuel and brake lines as well and was thinking if it's not too hard taking the body off the frame and getting some rust repair work done to it as well. Is there anyone in the Garland/Dallas area that has experience with...
  12. A

    Braided lines for turbo buicks.

    Does anyone know of any good kits for braided fuel, brake and transmission lines?
  13. A

    How many active Texas members do we have?

    We should take over I-30 one night...
Top