Recent content by 77 cruiser

  1. 7

    200R4 Aluminum pan

    Mine is sheet metal too.:giggle:
  2. 7

    200R4 Aluminum pan

    https://www.cpttransmission.com/200_4r_aluminum_finned_pan.htm
  3. 7

    2004R Transmission Code

    Sounds almost like the TC is locking as soon as it goes into 2nd.
  4. 7

    Dave Husek DIY Trans Kit?

    I don't see any kits listed on his site, or do you have to call him on those?
  5. 7

    Paint to use

    It doesn't need high temp paint, regular Rustoleum is fine.
  6. 7

    CZ valvebody, no kickdown

    Have you tried running the rpm up to about 1500 to see if it's better?
  7. 7

    CZ valvebody, no kickdown

    You should have over 200 psi @ full TV.
  8. 7

    200r4 KC VB governor modifications

    I tried that once just to see what it would do, didn't work very good. Went to about 7500 & didn't shift out of 1st.
  9. 7

    200r4 KC VB governor modifications

    When you shimmed the TV limit did the PT shift points go pretty high? I did my CQ to shift at 6400 & PT is pretty high & detent is sensitive.
  10. 7

    Offset pump seal?

    For some reason he didn't want that, I tried for him.
  11. 7

    Offset pump seal?

    Does anyone know of a pump seal with a offset lip to address a worn converter snout? Asking for someone.
  12. 7

    3rd 4th gear lockup switch location?

    It should still unlock when it drops out of 2nd.
  13. 7

    2004r died - under 200 miles self built

    He's not hard to get a hold of, or he didn't used to be. Seems like you have to call I thought he was a bit slow on Emails.
  14. 7

    Governor spring

    Goes on the light wt.
  15. 7

    Transmission pressure gauge readings, what do you think

    Might have some sticking spool valves, only takes a speck of dirt.
See more
Top