Recent content by 6pk2go

I have a used MAF to add to this. $100 for all. Contact me at tonycrush14@earthlink.net

After many yrs I am getting my 85 GN back on the road. I am having trouble remembering how the wiring harness snaked across the front of the engine particularly the left side. Does it go under the pwr steering pump? Can someone post a picture of theirs for me?

Can I see the timing chain tensioner through the fuel pump blockoff plate or some other way without pulling off the front cover. I had the motor rebuilt w/dbl roller chain but I'm not sure if the tensioner was installed or not and I would rather not have to pulloff the front cover

I just had my motor rebuilt and had a dbl roller chain put in. I'm not sure if the rebuilder put back the chain tensioner. I understand it should not be installed w/the dbl roller chain. (1) can it even be installed? (2) will any damage occur if he did install the tensioner.

I just had my motor rebuilt and I gave the rebuilder a dbl roller timing chain to install. I have since seen comments that the chain tensioner should not be installed w/dbl roller chain. I am not sure if he installed it or not. Will damage ocurr if he installed it and can he even install the...

I have my rebuilt motor back and the rebuilder has a tag stating to retorque the heads after 1/2 hr of running. I think I can get to the bolts w/extensions and universal joint but I'm concerned the the torque values will not be correct. My questions are do the heads really need to be...

I am about to rebuild my 85 and am considering Poston's GN107t cam. What are experiences by other on this cam I also need to pass CA smog. Is there another cam others like better?

I just bought an '85 motor and trans from a wrecked GN. It is supposed to only have 30k on it. It has been sitting as the hoses are all dried up but the paper is still on the valve covers so I believe that the mileage is probably correct. What precautions or changes should I do before...

I have 200K on my engine that was bored .30 I assume to rebuild it again it will need a .30. Can these be taken out that far without overheating or other problems

Postons headers I have them installed and they went on fairly easily. Mine have cracked slightly on the left side just above the flange but it has never gotten any worse unlike the stock headers. I ocassionally hear a tick at startup from the crack but it goes away I suppose as they heat up...

low fuel light on digital dash Can this assembly be made to work on a digital dash? Looks like you would have to cut the film to fit the assembly into the hole.

I want to install the cooler in conjunction with the coil in the radiator. I would assume I would go into the radiator and out through the cooler and back to the trans. My question is which line going to the radiator is the feed and which is the return -- upper or lower?

Who in the LA area would carry short blocks for 3.8 Turbo. Mine's been bored .030 and w/120K I don't want to bore it again prefer to buy a short block. I like Grooms ad in Tenn. but probably to far to be shipping engines frt probably a killer.

Reading the ranges in TX that UNGN posted for smog makes me wonder about the ranges I/we are held to in Calif. I have had to go to a "Test Only" station now for the last two checks I assume because as my certificate states I fit the "high emitter profile." I have posted my results below I...

just installed TA33 I just had mine done by Limit Eng, it took about a week after he got it. Shipping included $836.73. You can see below my mild modifications and I can attest to a significant power increase. Just bolted right up, he will send you new fittings, gaskets and nuts.