1BUICKTtype's latest activity
-
11BUICKTtype replied to the thread 3" Downpipe RJC vs GBody Parts.RJC is the only one to get
-
11BUICKTtype replied to the thread HR poly motor mounts.yes, by turning the pins to the flats instead of the round, the motor will sit lower. with mine on the round (default setting) part, the...
-
11BUICKTtype replied to the thread HR poly motor mounts.My HR mounts came stock with the pins on the round part while sitting on the frame. I think the instructions say to leave it this way...
-
11BUICKTtype replied to the thread Lokar LS1 oil dipstick works.the Lokar dipstick is adjustable but mine read full with 5 quarts out the package. had it not been right I would put 5 quarts in and...
-
11BUICKTtype replied to the thread Mahle or Fel-Pro Valve Cover Gasket.VS50156T
-
1I was removing the driver-side header and while I was unscrewing the nut that attaches the dipstick tube bracket to the header, it was...
-
-
11BUICKTtype replied to the thread fixed antenna mounting.for anybody who is trying to figure this out in the future, there is a hole inside your inner fender. inside that hole is a metal tab...
-
-
11BUICKTtype replied to the thread RJC valve cover spacers & Heater box shield.how do you attach the one oval conduit bracket after the shield is removed?
-
11BUICKTtype replied to the thread Boring stuff - valve cover gaskets.VS50156T are the best valve cover gaskets. not sure why anybody would use single use cork gaskets anymore.
-
11BUICKTtype replied to the thread radio/deck install not lining up to dash.they do not as the original radio/deck only had 2 bolts holding it in which is what I was expecting for this new set-up as well. I...
-
11BUICKTtype replied to the thread radio/deck install not lining up to dash.I've swapped them from left-to-right, top-to- bottom, and even tried installing with the "TOP" of the kit on the bottom and the most I...
-
-
1Hello, Can somebody tell me what I am doing wrong? I can't seem to get more than one bolt hole lined up to install my new radio/deck. I...
-
-
11BUICKTtype replied to the thread Torque Spec for Stainless Fasteners.ah that makes sense now i guess. since the hardware is stainless, they require some sort of compound on the threads thus changing the...
-
11BUICKTtype replied to the thread Torque Spec for Stainless Fasteners.not sure why the kit says not to exceed 20 ft. lbs. for hardware on the engine that calls for more than that...
-
11BUICKTtype replied to the thread Torque Spec for Stainless Fasteners.you need to throw that junk stainless hardware out and get the stainless ARP's from RJC Racing that are nearly as strong as Grade 8
