Recent content by 1000MileStylez

1986 Buick Regal and whole lot of extras. Open to offers. Car weighs 3210lbs w/o driver Engine Machining performed by S-K Speed,Lindenhurst Long Island 109 block .020 over JE Forged Pistons Crower 4340 H beam rods Eagle crank internal balance Comp cams hydraulic roller 218/212 Morell...

do i just zero out the tables or i heard to set the idle rpm range to 15*

I didn’t know about the timing offset page. I’ll set that all to 0. Tdc is at 0 when piston is up on comp. That helps thanks. Since I made this post did more digging and I have other factors involved like my msd box not set correctly. Also found that my heads an early set of champions only take...

Have a 218/212 roller cam. Trying to get the car to idle properly using classic fast. What is a reasonable cold start idle speed?

By miricle got the engine running somewhat. I think my timing is way off. I want to check the base reference angle. How do I go about doing this. Which screen should I be looking at while I’m checking the balancer and what mark on the balancer should I be looking at?

This is with an 8.550" pushrod

So i was setting the lash on my motor. I noticed on #1 cylinder I moved the pushrod up and down and turning while i tighten the poly lock down then i give it one full turn for preload with a ratchet and lock the set screw, then on 3# and #5 cylinder when i repeat the same procedure when i want...

They appear to be g body spindles from all the pictures i have seen online. My center links match up on the new kit i bought compared to my old. However one of the tierods dont fit at all.

Could anyone please verify these measurements?

All my old rusted moog parts fit. These are a different manufacturer. I also use to have 72 camaro spindles. I forgot what steering parts were my old rusted ones. Ugh.

Last year i bought lowering spindles. I just purchased a kit with all the tierods. I found that the tierods dont fit the center link or i have them backwards and it doesnt fit the spindle. Could be they sold me the wrong center link. The upper and lower ball joint on the control arms appear and...

Never mind. Figured it out.

Redoing my harness I'm questioning the wiring for the turn signal. Brakes. Could someone send me a cell phone video of how the light up? I'm having a hard time. Do the brake lights void the turn signal when you're braking? Are the small 194/168 bulbs parking lights only?

Race car guys do you have it wired to a switch where you manually turn it on with relay or do you have it wired to a relay and just come on when ignition switch is turned?

Sold