XFI VE table.

[srz]

Finally got the car started up after a yr scratching my head. Not enough FP so I really feel like a ash-hole. Cranks on 1st strike of the key but looking at the VE table the bubble is hovering at the top in the 315kpa range @ 900rpm's. This is real new to me so I know I have a STEEP learning curve ahead of me but I'd like to tackle this and figure out how to get it down. The car is so rich I can't let it run for more than 1 min as it looks the the top of the engine is just straight fumes. I've looked in the helps files but not much help there.

Silas,

 

[Chuck Leeper]

What's the MAP reading, key on, engine off?

Are all sensors reporting correctly?

 

[srz]

I'd have to go check as I didn't check prior to starting the car. All the other sensors are w/in spec or calibration. 11pm here so I'd have to check tomorrow and post what I have.

 

[EightSecV6]

need to make sure the progam is set for the corect MAP sensor, if it is, it is a wiring issue but easily corrected. What wiring harness are you using?

 

[srz]

Wire harness is from Horsepower connections. It's set for a 3 bar.