How to hook up sensors and read them on the PL...?

[Soldier_GN]

Finally gettin the GN worked on... Havin a PLX WBo2, Alky w 3 bar MAP sensor. Do you just need to run the wires to the analog box to read theae items on the PL ? And can you read boost on the PL by just splicing into the boost guage and hooking to the analog box? If not, how can you read boost on PL. I had the thread saved before the new page layout, but lost it somehow....Thanks TB...

 

[TurboDave]

For the WB, you hook the signal wire from the WB to the analog block (I1). As for reading boost you tap into the signal wire from the 3 bar map and send that to the analog block (I2). Then on the powerlogger config screen you tell it what wb you're using and what map sensor.

 

[Soldier_GN]

Thanks Turbo Dave....you Navy guys are always smarter than us dumb Grunts...lol

 

[TurboDave]

Thanks, and some of us sailors can even handle a weapon! Navy rifle team (1975)