I can't get over 20 lbs.
With alky control on 8
I do have a bad drivers header leak which just bought a pair that's been repaired hopefully when I put this on it will fix my issue sometimes I can run it a 6.5 rough and no knock the sometimes I have to put it to 8
I don't know
I got it the damn hose into the throttle body popped off went over car for 2 hours and missed it called alkycontrol talking to them and looking at front of car I finally see it.i feel like a dumbass
Turbo maxes with 20# and gain on alky on 3 car runs well now next weekend LS1 maf and translator...
Just finished install,did all the tests.tpok car out for a drive wants to die no power ran it up and down street a few times no change.put in garage idle just fine
Any ideas
Could it be map sensor and can I put old 2 bar back in and try it
I haven't yet,it's right by downpipe.so trying to figure if I can cut it back further and up past down pipe and use hose on each side of it so it doesn't melt
It's fuel,I just looked at it well and did not no return lines were on passenger side of car,my stupidity now I need to figure out the routing to replace them.Does not look like fun at all,any advice on this would help.
I just got done putting pypes 3" on my ttype fired it up noticed drivers header leak which I'll address but there was fuel running down the test pipe.i cannot find a leak.i did t even jack car up in front or touch anything in front of test pipe
Anyone have any ideas