Search results

Hello, I felt like the existing aftermarket transmission mounts were overpriced and some purposefully omitted information. I designed and ordered these to allow for use of a standard Poly TH350/TH400/700R4 trans mount. They are anodized black and include threaded(M10x1.5) holes for the...

Hello Folks, Are there any options out there for aluminum oil pans? I'm investigating making them myself. I would like to retain the same depth, but add wings to increase capacity to that of a deep sump. Also improved baffling, depending on interest. Stock LC2 is the 20 bolt pan if I...

As the vehicle warms up the idle surge will get worse and worse, eventually the car will stall. I have adjusted the min air screw to range all the way from 15 to 40 and regardless on setting the idle will not stabilize. TPS is 0.42 or 0.44 volts. IAC will decrease to ~20 and then suddenly...

video of noise here I need to drive this for part of a friends wedding in 18 days. Do you guys think this is a torque converter noise? or a trans noise? Motor is fresh and has good oil pressure. decided to romp on it a little on the way home and it shifted fine but started making this...

-Ta performance Hardened and grooved cam bearings -Comp 212/212 flat tappet. -stock untouched 109 block cam fits fine in rear 3 bearings. when I installed the front bearing the cam barely fits through and I can barely turn it by hand. I had to remove the bearing and scotchbrite the bore and...