Search results

I need a 3" maf pipe. anybody have one I can buy? don't care if its chrome, polished, or painted.

i guess you could say that she found the fountain of youth. the odometer and trip odometer quit working. Speedometer, tach, and everything else is still working though. Can this be fixed, or do I have to get a new cluster? Same thing happened to my Syclone several years ago and I ended up...

someone broke into our shop and stole my dad's 1972 SS El Camino. 454 w/ 4 speed all matching numbers. The car is white with blue stripes and the dash is out of the car. the hole in the floor has been modified to fit a hurst shifter. The motor and trans are in the car, but it doesn't run...

Now that TTA1138 is back on the road, does anyone recommend a place to get an alignment in the DFW area? I would prefer not to just pull up to some random auto shop.

I have always noticed a difference in the speedometer reading and my scanmaster. At 75 mph on the speedo, the scanmaster reads 70 mph. What would cause this?

The alternator on the TTA started to make a squeaking noise so I took the belt loose and rotated the pulley by hand and the bearing was trashed. So I got a rebuilt alternator from Orielly's and put it on. After about 15 minutes of idling, it started to make the same sound as the other one. I...

when I turn the key to start the car, the radio cuts out and the temp gauge jumps to maximum, and one of the relays pictured below also clicks (its hard to tell which one it is). the motor won't turn at all. no fuses are blown, and all electronics work when the key is in the on position...

I took the dashpad off the TTA to look at the speaker wiring and got some good pics of how the PowerLogger fits. Here is a close up of the top of the PowerLogger module installed. There is about 1/4 inch of clearance from the circuit board to the dash. I installed it months ago, but was...

I need 2 (one for each side) new t-top outer rubber strips. Mine are wavy as shown in the picture. I would like a new set that are straight. Also need a new front left piece that is shown. i went through a dip and it didn't survive. The dealer told me that both of these are not...

Is there a LSPBC meeting tomorrow (3/19) at Chucks? anyone going?

I have some Global West subframe connectors for the TTA that I need welded on. Anyone recommend any local suspension shops? I am in Arlington.

$200 shipped. Basically brand new. used only twice.

New, never used, LC-1 cable. WB02 sensor not included. 170.00 shipped.

just as the title says. new or used, as long as it works.

I need the electrical connector that goes to the AC compressor (the one that connects near the clutch). When I removed my compressor, I found that something had shorted and melted the connector. if anyone has one, shoot me an email.

I ordered a replacement AC compressor from GM, PN 88964869, for my TTA. When I compared it to the original one, the clutch looks different. The pulley is the same diameter, but the clutch is smaller. Has anyone used this PN? or have a compressor like this?

I need a tensioner pulley for 89 TTA. the tensioner housing seems to be fine, but when my AC compressor went south, it got into the tensioner pulley and screwed it up. I assume a GN one would work also, so if anyone has one, shoot me an email. Thanks.

Buick vs. Ford 2006 I have never been, but I am going this year in the TTA. Anyone else planning to go?

Used Turbolink 4.0.6 - $245.00 New K&N 9" Cone Filer (3" inlet) - $35.00 Used TurboTweak Alky Chip - $40.00 Setup for 50 lb injectors, PT-51, 2800 stall, 23/21 Timing, 206/206 Cam, 24-26 PSI, and Maf Translator. Used for approx. 6000 miles. Used 50lb Thrasher Chip - $30.00...

Is the ac compressor the same as the GN? I have P/N: 88964867 for the GN compressor. My ac compressor locked up today, so its got to come out.