Search results

I tried all the above at one point in time,and none of it helped. It wasn't until I got out the Mic's and started checking the nylon gears. I found the speedo gear was warn, but you sure could not tell by looking at it. But a new gear in...all is fine and has been foe a long time now. All the...

I did do that,I just didn't know if I should mount seats on top of carpet. Thank you very much

About three weeks ago I bulled my seats and carpet to install new. Three weeks is about two weeks past my ability to remember anything any more?? This is AFTER making a mental note on things to remember. It also seems that this is about 2 weeks 6 days past my of remembering said mental notes...

I found a bad female connector pin on my coil pack connector one time,pulled it back out and it fired right up.

Thanks again for the help.IT IS ALIVE! I was looking things over with the print out you sent, getting ready to do the testing. i disconnected the pig tail from the coil pack and thought that two of the female looked pushed in to far. C and G or H. After pushing them up some,I cleaned the...

Thank you so very much. This I think I can do. I just needed a different explanation than what my mind was sputtering on. I did put a new crank sensor in just in case. Could the cam sensor still be off 180deg, I set it with the piston on the up stoke marks aligned. I will not have the chance...

This is a re-post of a question I asked in the hot air forum,but never got any response. Maybe I asking the wrong question the wrong way I don't know. Any way I'm going to get what info together I can and just start probing some wires and see if I can find something. If you can offer a simple...

How can i check the connectors to the harness for power,and how do i test the harness it self.

Hi All, I have a no start condition. I do have spark,and the fuel pump starts and prime as it is supposed to. cam sensor was set using Casper setting tool. I do question weather I am on the compression stroke, I had my finger over the spark plug hole,checking for air escaping. The engine...

Thanks, but I have one on the way.

Yes. I have one on the way. But if it doesn't work out are you willing to part with just the housing?

Folks, As stated, I need a decent (flat) housing for a 84 hot air. I also posted in the parts wanted section also. I thought I would go right to the source. Thanks Mart Urbanski

As stated, I need a decent housing for a 84 hot air, Thanks mart Urbanski

Look up a S & W model 41. Great target pistol, fine machine I've had Rugers and Buckmarks. I shoot the 41 in bullseye competion.

OK thanks. I just have the wires laying out to Figger out what they do. I'll get them all tucked away before I'm done. trying to clean up the wiring is how I got myself into this. Mart

How do I activate the fuel pump using the connector in the engine bay?

Hmmm. I was thinking they might be for a coolant sensor gauge. PS. I HATE WIRING.

Hello all, Somewhere along the line I lost track of these two wires, one red one green. They come from a junction in the main loom. some what near and between the coilpack and water pump. I have been trying to dress up all the wiring when I put this engine back in. So far the engine will turn...

And what is wrong with a hotair?

Hello all, found this thread this morning,and as I am giving my engine a detailing job before I install. I was wondering what I can install on the engine before I put it back in. Like the starter,crossover, coil,ect. It is going in with the trans attached. Mart