Search results

I'm looking for file fit rings for 3.840 piston with 5/64,5/64,and 3/16. I called Total Seal and they don't have them. Any suggestions?

Is it possible to file non file fit rings?

I just pressure washed my engine bay and k member while the engine was out. It looks like there was some type of coating I washed off the k member. What should I spray back on it?

Got the car with no radio. Scanmaster and smc velcrod and glued to the dash. Just used some 1/4 panel board with stick on velour type carpet over it. It's an old alpine I had. Wanted to see what it would look like. I'll have to make another one because I couldn't cut it straight with my...

I only have $4000 to spend. How would you go about spending the money? A lot of parts will have to be replaced or rebuilt. Here's what the car has: (1).030 block that's gonna need either a hone or another .010 added. Pistons are hypers. Stock crank and rods. Arp head bolts, arp rod bolts...

I just acquired a 87 t type. Always wanted one. The injectors that are on there are 009's which I just sent off to get followed and cleaned. TT chip that cam with car has #40 written on it. Shouldn't it have #42 on there? I would think it would make a difference. Pretty sure I'll have...

I've got my engine down to a shortblock and took out the cam. It's a DLS cam and some of the journals look a little scratched. Cam bearing all look ok except the middle one. Looks worn out. Is it possible to get the cam turned .010 and then get cam bearing to match? Also, Is it possible to...