Stage 2 built. 1987 Buick Turbo T - project -"Fall out "

image.jpeg


Thanks to Steve else for this nice 70 mm accufad
 
image.jpeg

image.jpeg

Antonio stojabov for this white racing modified timing cover with a modified external oil pump .
 
image.jpeg
image.jpeg


Thank again to Antonio S. For another piece of the bottom end for the stage 1 012 block.

Here is a BHJ internal balancer
 
image.jpeg
image.jpeg
image.jpeg


Got distracted a little on the engine parts for the S1 built

Here is one rare piece made my KB , a one piece air damn that was introduced in the mid 90s. Jpolzin had this stored for a while and I had to convince him to sale it to me ! This will be a great addition to project fall out.

I will have to modify the center scoop in other T for the cold pipes to make w
 
image.jpeg


Again , thanks to Jpolzin for this brand new full set of RJZ razor pulleys for the stage 1 built.
 
just a little brief write up on the whole parts as j still have a lot of updates to load up here.

The built will consist of a stage 1 012 block that was purchases in the north eastern part of the states and delivered to Houston tx

The heads will be a fully race Ported M&A revised aluminum head castings with over size valves and beehive springs. They will be equipped with scorpion style 1.7 rockers.

The intake as you may know is a early casting BGC off center that will be race ported as well and powdercoated in a un traditional coating. (Valve covers as well ).

The porting and polishing are being worked on by panhandle racing out in Amarillo Tx.

The 012 block will also be machined to a 262ci with BMS Buick Motorsport internals.

This setup will be run with E85 fuel system.

More to come ..
 
image.jpeg
image.jpeg
image.jpeg


Thanks to Chris Marin out of El Paso Tx for this great set of M&A heads.

These heads came complete including a set of valve covers , pushrod and stud mount arp bolts.

These were picked up initially in February of 2016.
 
image.jpeg


Back to the exterior of the turbo T. The passenger inner plastic well on the car was busted on the lower end of the well .. It took me 4 months just to find a good condition passenger inner well ! . Thanks to Robert wells out of Dells, Wisconsin he delivered as promised. A well conditioned part !
 
image.jpeg


The fenders were installed just recently. Next up is the installation of the passenger wheel well , and rhino coat all inner plastic wells. The factory turbo T wheels will be replaced with a set of 17" simmon wheels .
 
image.jpeg
image.jpeg

The arrival of a surprise.

Thanks to Robert aka AlaskaGN out of Alaska, USA for these amazing wheels.

17" simmon wheels with new BFG tires !
 
image.jpeg


For mock up purposes only. The pan is obviously a deep one and has a baffle insert including a low profile pick up unit.

Stage 2 block 012
 
You must log in or register to reply here.

Similar threads

Michael30815
1987 Turbo T WE4 (low miles)
Replies
3
Views
619
Michael30815
Michael30815
M
1987 Buick Regal Turbo T
Replies
6
Views
1K
mapmaker
M
D
Whats this stage 2 pro-street, 1400hp car worth?
2
Replies
20
Views
2K
Mr.Spool
M
TurboWh1
FRESH Janis Built 200 4R
Replies
16
Views
2K
TurboWh1
TurboWh1
R
1987 Turbo Regal
Replies
5
Views
695
Rayk
R
Top