Recent content by Wookie

  1. W

    Gauging interest in my Oil Booster Plates

    I sent you a PM.
  2. W

    ATR/KB Style 2 Piece Exhaust Crossover Pipe

    Anyone have an ATR/KB style 2 piece exhaust crossover pipe that they are willing to part with?
  3. W

    speedometer cable

    I got the speedometer cable reattached at the gauge cluster. :) Now I'm having trouble removing the old cable from underneath the car. It's detached from the transmission, but I can't fish it out between the frame, wheel well, firewall. This space is really tight. Any ideas, tips or tricks...
  4. W

    speedometer cable

    I'm in the process of replacing my speedometer cable. I have the new cable pushed in through the firewall but I can't seem to get it lined up with the gauge cluster. The cable is coming in above the steering column and below what I guess is safety plate. Unfortunately, I didn't pay close enough...
  5. W

    Knock, knock...

    I didn't have a fuel pressure gauge connected at the time. But, I did test FP to boost a couple of weeks ago and it was 1:1.
  6. W

    Knock, knock...

    I thought the problem was fixed, but I'm seeing spark retard on Scanmaster and Turbolink. Here are the new #'s at approximately 14 #'s boost. Any help will be greatly appreciated. Iac - 94# 36% Lv8 - 255# Tps - 1.86 v Int - 128# O2 - 796 mv Maf - 213 Blm - 116# O2 delta - 0# Mat - 79° Rpm -...
  7. W

    Knock, knock...

    I cleaned grounds at the back of the block and battery to block. Also, disconnected battery terminal and cleaned wire leads going to them. Good luck.
  8. W

    Knock, knock...

    I would like to thank everyone for the help. I followed Steve Woods instructions "How to find dropped voltage" http://www.vortexbuicks-etc.com/measuring_voltage_drop_across_a.html Cleaned up my grounds, I'm now seeing 13 - 13.5 volts at cruise. When I roll into the throttle the voltage stays...
  9. W

    Knock, knock...

    Here are new numbers recorded with Turbolink. These were recorded with the car in 3rd gear. I lifted off the gas pedal when spark retard appeared. Boost was between 8-10. IAC - 107 LV8 - 255 Tps - 1.74 Int - 128 O2 - 820 Maf - 225 Blm - 115 O2 delta - 0 Mat - 91 RPM - 3775 ESC - 3# Spark...
  10. W

    Knock, knock...

    No, the numbers are not at hot idle. They are at cruise then rolling into the throttle.
  11. W

    Knock, knock...

    I'm experiencing knock at low boost levels. In the neighborhood of 5-10 lbs. I don't hear it, but it appears on my scanmaster and turbolink. I'm using a TT chip, TE-44 turbo, 40 lb injectors, Fp line off is set at 43, upgraded fuel pump and hot wire kit. Here are the numbers IAC - 104 Lv8 - 243...
  12. W

    Methanol Sources

    Any places near Birmingham, AL?
  13. W

    ECM malfunction codes

    Please help! I'm receiving multiple malfunction codes on my turbolink v2.14. My ECM seems to throw out random malfunction codes when the engines under load. I have replaced the ECM. Also, I have a new TT chip. Malfunction codes occur with both the new and old chip and was happening before I...
  14. W

    Turbo oil feed line

    I just bought a new turbo and I'm having a hard time removing the old oil feed line. Is there an easy way or special tool to remove the old oil feed line?
Top