Recent content by Turbo317

Thanks for the clarification Mr spool

That's what I thought on the location. Doesn't the nozzle usually face the throttle body? Or do you face it into the air stream in this situation?

Guys that run nitrous and alky, where are you mounting your nitrous nozzle. Before the alky nozzle? After that alky nozzle? In the plenum? Wet or dry kit?

using the tach on the scanmaster, stalling 2450rpm with a gt6152. I have put about 10,000 miles on it. Not sure how many the previous owner put on it. Not sure what these are going for nowadays. Any fair offer takes it.

For the 200r4. Something that is in decent shape.

Maybe Ill come out. Been having some health issues and trying to limit what I do and eat. See how I feel in the morning.

I have a stocker from IC car. unknown milage. Minimal up and down play. Alot of in and out. No fin contact, still made 25 psi and pulled hard. It just smoked pretty good. 1 bolt hole in the out return will need a heli coil. $125 shipped. no actuator.

The software sometimes fixes the issue unless the chains are stretched too far. They aren't bad once you do 2 or 3. Drop the whole motor/trans/cradle and all. Pull up a chair and go to town.

Mechanically they are the same. We sell alot of them and people seem to like them. I have done about a dozen timing chains because they stretch from lack of regular oil changes and then cause a check engine light. 3-5-R wave plates breaking, power steering clunks, whine, and sqeaks, and...

SWPA Motorsports - View topic - Race Gas

Tim, I got a stock turbo on my car. Its spools and pulls hard. Minimal shaft play, however its starting to smoke and there is some oil getting into the cold side. Its going to need seals sooner or later. Let me know if interested, I'm looking for something a little bigger if you got...

Stock Driveshaft I had it cut 1 inch, rebalanced and painted about 5 years ago to use when i swapped over to a th400. when i switch over to a th400 and have gone less that 500 miles since then. Maybe 20 mid 11 seconds passes since then also. Comes with a good 1330 joint on one end and a 1330...

I'll take the one for the accufab doghouse. Take paypal?

those trucks will still run on 35psi or so of fuel pressure when spec is 60psi ish. check fuel pressure and fuel trim and go from there.

hmm i can't say i do know any of those guys. I may reconize their cars but i don't know any of them