i think i may have found my issue ! maf reading only 55 at wot !!!! so gota find new 3.5" ls maf ! gona try one off buddies escalde tomorr just to check !!! but thanks for reply !!!
scanmaster was af reading ! and got gen2 set for ls1 zo6 maf and extender/pro ! i think this maf is shot came off nitrous huffen 6.0 gto that goot smashed !!! gona try to find another maf and see what happens !!! i could have sworn the other day maf was higher !!! but been so frustrate that...
ok just took car for another test drive and notice af reading was at 1 at idle then only went up to 52 wot then car cut out !!! that is waaaaaaay too low correct ???? is zo6 maf ??? could it be bad ??? wot should be in 300 range ???
look up smc customs and call steve !!! he is in your area and would know of ant good tr technician around you .. he makes smc alky kits and will help you all he can !!! hes a real good guy !!!
jay c from bigwood racing has new 4" one piece !!! ck his site out !!! there are many out there !!! ck them all out and see whick best fits your set up !!!
hey jay ! this might not mean anything ,but now the fuel level gauge is way past full, can barely see neddle !!!! still chasing wiring !!!!! im driving my wife crazy !!!!
do you have a scanmaster ? if so can go to tps with key on engine off and hit gas pedal see what it does ! should start at .44 go to 4.6 or so ! are you running tps tech enhancer ? i just had to throw mine away stuck tps at 4.68 at idle !!!! but green light was on showing in range but it wasnt...
well same crap !!!! jay i have gone over every wire on car !!!! and to clarify the scanmaster did not go blank just dropped milv like crazy !!! wich is normal with car cutting out !!! but scanmaster did not loose power !!! im taking it to a friends house and let him look at it !!! he is a...
i will im gona go see if can reroute it and take it for a try !!!! im gona go crazy if this isnt it !!!! man jay i cant believe i didnt see that yesterday !!! thanks again JAY C !!!!
no jay i did ck everything we talked about yesterday, but just didnt see the header on wire !!!! ck crank sensor like u told me and swapped module and coil still same even put tt chip back in it ! so i did listen to what u told me just didnt see header laying on power wire !!!! probly just...
hey jay i checked everything but that power wire i tightened all my grounds but did not see that header on wire !!!! i was just fixing to call you on the phone !!! i hope this is my problem !!!! cuz this is driving me freakin nuts !!! and to anyone else who reads this Jay C is the man he took...
hey heg i looked at power wire from batt to starter and my headers are laying right on it and feels like poss burnt thru wire ??? cant really see it but will move wire or replace if burnt !!! you think this could be my issue ??? man thanks again for the help !!!