Did the splice work? I am having the same issue! No power getting to the coil! (I know this because I put my test light from the control wire to the common feed wire on the module had my wife crank it and no power!) I have tried two other modules with no luck.
Thanks for any help anyone can...
Jim,
I just got in on this raffle for a new TA Alum V-6 block from hrpartsnstuff you can find it in parts for sale down under NEW TA Alum V6 block for sale.
Jim,
Did you take that job in Woolwich? I got my new P255/60/15 M/T ET radials mounted on my new 15" X 8" Draglites today! They look nice! I have been driving the Buick to work the last few days got about 100 miles on it now.
I just put the RJC exhaust on my 87 GN this weekend. The install turned out okay in the end but it did take some work. The bend that comes in to the muffler coming from the test pipe gave me some issues, it was making the muffler sit at an angel and I had a hard time getting the drivers side...
Thanks for all the ideas everyone!
I got them working today!:) I put all new bulbs in it to make sure that they were good and it came to life. I didn't see one that looked bad but i guess one was. The only issue I have now is the flashers are very dim and blink slowly, I am going to put a...
I have an electrical issue!
I am just getting my 87 GN on the road after a spun rod and main had it sidelined for a while. I am trying to get some break-in time on the rebuilt engine and transmission but I have no turn signals and no hazard's. I have replaced the turn signal relay and the...
No turn/hazard lights
I have an electrical issue!
I am just getting my 87 GN on the road after a spun rod and main had it sidelined for a while. I am trying to get some break-in time on the rebuilt engine and transmission but I have no turn signals and no hazard's. I have replaced the...