Recent content by mart54

Interested, sending pm.

Figured you turbo guys would know. Will it fit a 350 Buick V8 crank? My tooth count is 160 and slightly over 13 & 3/8" dia. Center hole is 2.485 Looking for a SFI rated flexplate for a internal balance stroker build, see there are plenty available for you turbo boys.

For some unknown reason, I'm not getting any pm's. Call Me at 586-770-2416. Mart

See pics. Ask if you need more info./ specs.

Looked like a nice deal.

In line if deal falls thru.

Kurt, Call this guy (Dan) 586-247-2467 immediatly. See if he still has it . It's 26,000 mile all orig. UNMOLESTED, no oil leaks, etc. Tell him Marty sent you.

John; I'm going to pass on the convertor and have a new one built for my combo. Thank you for your time. Dave your up!

Interested and waiting on you John. Thanks, Marty

Interested in Convertor. pm me. want to put it behind a built 355 sbb. Mart

200r4 BRF trans, with manual dash switch. Convertor was locking fine for a day, now it quit locking. Dash switch is good, along with fuse, just installed AC Delco 2 pin pressure switch. Ground wire from (2 wire)TCC solenoid grounds to valve body., 12+ wire from TCC goes to 1 pin on pressure...

Thanks, but I'm gonna pass. Its an in tank pump.

Interested,Can you post pic? I'd like to see if it's the same as for a 350 v-8. I know the timing covers are. Marty