Recent content by KansasGN

It has happened in 2nd twice, and I haven't done it anymore, concerned I was going to trash something. 1st gear is the manual transbrake. Fluid level is spot on according to dipstick but it could be off, good thought. Has a deep Hughes pan and was told has a 700r4 filter. I just bought it about...

I just bought an 87 GN, tranny seems to work fine under normal driving conditions. I was told tranny has been built, so I really have no idea on the internals. I do know has a manual trans brake, deep pan with temp gauge, Pro Edge Converter, fluid looks good. So when you launch the car it leaves...

The cable you need is a DB 25 male to female and needs to be IEEE 1284 Compliant. They are readily available just do a search for them. Here is a link to one. http://deepsurplus.com/Computer-Cables-Accessories_2/DB25-Male-to-DB-Female-IEEE-1284-Cable/6ft-IEEE-1284-DB25-Male-to-DB25-Female-Cable

Sounds like you might need a new compressor. Might get a professional opinion, but if it sounds that bad, prolly is bad or close to it. Do you have access to R-12? Might be the time to install a new compressor, convert to 134, check the system for leaks, then charge with gas and get down the...

I'm located about an 1 1/2 hours South of you. In Parsons, if your familiar with Pittsburg, I'm about 30 miles west of it.

Yeah that is it! Take the connector off of it and put a wire across the two female connections in the plug and see if the compressor runs.

Hey Danster I was looking at the wiring diagram (provided to me by Scott ATK and gsgns4me) and looks like the Hi side of the switch (orange wire) runs directly to the Blower Relay, bypasses the blower resistor. So I'm thinking the blower relay might have a problem. Do you have an extra one of...

Switch Could be your low pressure refrig switch. Its on the pass side eng compartment and has two wires that should be pluged into it. The wires are light green and light Blue I beleive. Verify that it is still there.

Just wanted to say "Thanks" for the replys! This Board is Awesome!

Yes they are. I havent had time to dive in it yet. I think with the Diagrams should be able to locate the problem. Thanks for the reply.

Thank you Thanks alot! Greatly appreciated! Those are awesome

Thank you That will help. Thank you for taking the time to that. I'll let you know what i find. Thanks Brock

Thanks for the reply. First I jumped it and that didnt work so I checked for voltage and didnt have any. Theres a relay I wanted to check, but not sure what is what on it? Thanks again

Does anyone have a A/C wiring Diagram for a 87 GN. My AC quit and not sure what happened. The fuse is not blown, have checked the charge and the pressure switches. They are fine. Have lost the 12v between the AC Control and Compressor. Any ideas on how to locate the problem. Thanks Brock

Any offers?