Recent content by joyce1

I will take one let me know how to pay.Thanks

Like title says need intercooler fan,Have paypal.thanks

How is this cam for valve train noise.

what stall is it? what was your setup you got it for?thanks

Checked line bias valve same one thats in ck shift kit pictures.Ordered new pump maybe have by weekend.Will install and see what happens. Thanks again.

Took trans back out and took pump apart. Slide springs are fine but pump mating surfaces scored pretty good.Guess I well order a new pump monday. Is there anything else that can cause this? Thanks.

I never took the pump apart.I took pressure reading before freshing and thought were ok.But I didn't check them at high rpm before.This my be why it never shifted right.I've been doeing some seaching think its probley the pump slide spring.Took for drive shifts good at part throttle but...

Hi I just freshened trans with a ck rebuild kit and shift kit. Got in car and took pressure reading on jack stands. min tv max tv idle max tv 2-3000 rpms p 90 275 190 r 180 275 190 n 90 275...

Fuild level is right.Used dex 3 oil.TV is right.Does the 4th gear pressure switch have anything to do with the shift or is it just to send signal to ecm.Thanks.

Hi I changed trans oil over the winter.Took car for a ride today and the 3-4 shift real slow.Any ideas what causes slow 3-4 shift.Thanks.

Just got a set from Full Throttle today and had one that the pin fell out just like yours.Will be calling them tomorrow.

How much for just a trans with no converter set for up for lockup. Thanks.

No I did not have the roller rocker back then.I have the cam card right here only other number I see is part #69-200-8.Thanks.

Cam is a grind # BV69 258HR10.Serial No UG1567.I've tried 25, 50, 75 thuosands preload makes no differance.The noise is not real bad just that sewing machine sound.Everything in valvetrain is right.Back years ago I had a KB 1XT flat tappet cam that made noise to.I swithed to a atr cam and...