I’m not set on buying one just yet but..My car had hooker super comps headers on it when I got it. It was an older build so it had a lower wastegate installed on it. The welding was terrible on it so it had a terrible leak. Not only that but the gate was frozen in the open position it was on...
Bumping an old thread. Looking to do this to my PS intercooler, or something similar. I found that my cheapo intercooler that had been repaired is leaking.
I removed these from my car. I took them off because of a large voltage draw on my electrical system. I had a set of LS1 fans laying around that I was going to install on my Trailblazer SS (traded for a Tahoe) but never did. I used the wiring harness that I had purchased for the install on the...
I should have been more specific, my fault....I searched the pick and pull yards for 2wd Blazers/Jimmy's and the Bravada's in my area. I found nothing but 4wd versions and 2wd s10's but they have the same brackets that a gbody has. I know where to find the brackets, just cant find any vehicles...
The thread is a few years old but.....I cant find the passenger side bracket. The number is 15008834 and is discontinued by GM (they still have the driver side available). Ive looked at pick and pulls and cant find any in my area. So anyone know where I might find one. Tried Amazon, Ebay...
I did the blazer front brake conversion and noticed after the conversion the front brake hoses are turned at an odd angle and may cause premature hose failure, So Im looking for the specific blazer L brackets that come on 2wd 98-05 Blazer/Jimmy/Bravada models. They are part numbers 15008834...
I typically support vendors but I got all the fittings and more hose than I need for a little over 100. It would have been easier though to just buy a pre-made kit