Recent content by buickbob

Good advice. Where in PA are you? I'm in the North Hills of Pittsburgh. Bob

I have a 86 GN with a standard dash. I bought a digital dash that the person thinks came out of a 85 t type. What do I have to do to swap them?

I had to cut the left rear frame section out of my 86 GN due to rust. I'm welding in a donor section and I need to replace the cushions. I ordered the #6 & #7 rubber cushions from GM a month ago and there still not in. So due I use the poly bushing kit from ENERGYSUSPENSIONPARTS.COM for...

Does anyone have the part # for the body mount cushion's that's used on the GNX only? It's the one at the hump for the rear axle.

I have to replace the left rear frame rail section due to rust. I was going to patch the rail but I noticed that the body mount is gone and so is the cushion. I'm going to cut the rail out and weld in a donor section and while I have this out I want to replace the cushions. Who has good cushions?

I have a ATR 3" SS exhaust with the straight pipe in the muffler. The welds on the pipe inside the muffler broke loose and most of the material is gone. I was wondering if anyone knows of anything I can use to put back in there and then I'll have the pipe retacked in place. Is motorcycle muffler...

Thank you gentlemen I'll do that tomorrow.

The knock retard read 36 at idle. The sensor specs say it should be zero at idle. I did the TPS/IAC adjustment before I replaced the IAC. My o2 cross counts are zero at idle and the specs are 10-20 at idle if that helps.

I don't know what kind of scanner it was. I'm not detecting any knock. I did the scan at idle and at operating temp in closed loop. The chip is stock as far as I know. The prom ID is 7464 if thats helps. I went on the link for the specs and thats why I have some ?. I noticed the IAC count...

I scanned my 86 GN with a friends scanner and my spark advance program read 36 degrees, my IAC IS 60, my knock retard is 36, and my o2 is jumping between .20-.86. I put a new IAC before I did the scan. Some of these readings don't seem correct any ideas.

I realized after I sent you the message you where looking for nos.However I'm sure these bowls are up to standard or Brian wouln't be selling them. He went asfar as sending me a used bowl to use until my new one came in.

Brian at GBODY PARTS just got new ones in. I got mine last week.

If I'm not mistaken I think both locks run through the drivers switch. That might be your culprit.

Does the 3 wire o2 sensor work in place of the single wire o2 sensor without changing anything and what is the advantage of having the 3 wire sensor?

I forgot about your chrome ?. Theres a company in PA called Branden Enterprises that I met at Carlise and he claims he can rechrome plastic parts. His phone # is 215-327-4926.