I was able to tighten up the front cover adaptor so that both lines were vertical and it took the kink out of the line.
Thanks for the advice.
Now when I start it up the low oil pressure light comes on. I tried cranking the car for 30 seconds with the orange ecu wire unplugged but the light...
I am in the process of installing a pte turbo saver but I am having a problem with the line in the middle of the front cover adaptor having a slight bend in it after everything is all tightened up. If I route the lines under the swaybar the kink is worse.
Any advice will be helpful
Thanks
Im in the process of installing a Ta performance stock style timing chain. So far I put on the new chain dot to dot and now the front cover is on. The problem is when I try to find tdc (watching #1 intake valve go down) the mark on the crankshaft pulley doesnt align with the plastic tab on the...
Thanks hesermon for the response. When I unplug the low beam, the high beam on the same side goes off. I noticed that when I unplug the high beam the low beam seems to get slightly dimmer and when I plug the high beam back in the low beam gets slightly brighter. Looking at the connectors they...
After a couple of months of not driving her I noticed that last night my headlights were really dim and the highbeams have a little glow in the light during lowbeam, but highbeams work normally when switched. I just replaced the battery and I am currently running sylvania silverstar lights...