Buick Parts For Sale

[MGTech30]

Hello, I have many Buick parts for sale, will send pics. Unless it says GN or Regal directly in front of it it can be used on both Regals and GNs.

L&R fenders + inners, GN stock injectors 29lb, GN 37lb injectors, GN stock (crushed 31.5psi) fuel regulator, '87 GN body shell, perfect park lights, passenger door (power), clean '87 Regal vin#, 2 black antennas, Regal hood, Regal steering column, 4 Regal hubcaps, 2 chrome & 2 black quarter windows, lots of trim and molding (chrome/black), AC condenser, compressor, 2 heater core assemblies, 2 sets rear springs, Regal radiator, 1 Regal & 1 GN rear wire harness (lights), chrome driver side light bezel, Regal speedometer, Regal speed-o and ac bezels, dash assembly, V8 frame mounts, GN 7" air filter, various AC plumbing, windshield washer bowl, Regal carb air damn, Regal cruise control and carb linkage, Regal shifter linkage, rear sway bar supports, drive shaft brace, CPU covers, Regal ashtray, Regal wood grain door trim/panel, AC control unit, 2004-R control solenoid, '85 GN passenger side header, 3 "6" cylinder power emblems (hot air intake), New in box 8.8mm accel wires, New double roller timing set, misc. '87 GN gaskets + Hi-Po cam bearing, GN stock rolled filleted crank, GN stock cam, EGR cover, GN brass turbo feed fitting, New negative battery cable, GN New Bosch O2 sensor, Regal fuel sending unit, Regal gas tank, SUPER RARE '85 GN Coil pack with CCCI plaque on it, trunk, driver/passenger side view mirrors, '85 GN/T-type rims.

Email me at mgtramel@yahoo.com or text me at 6783680647 or call after 9PM M-F any time F-Sun or any time if you have T-Mobile.

Mike T.

 

[Ken Adams]

Tell me more about the V8 frame mounts

 

[MGTech30]

V8 engine mounts

You WILL need these if you are planning on using a V8 in a factory V6 car.

 

[Ken Adams]

Are they from TA Performance?

 

[MGTech30]

I believe so but not sure, I am sure that there is no difference in the materials going into making these.

If you need to buy them they are only $13, shipping should be about $3-$5 with USPS.

Thanks,
MGTech

 

[turbobooster]

do u have a good work ing stock 86/87 maf sensor?

 

[MGTech30]

Already sold it, sorry.

 

[Ken Adams]

Have you actually used these motor mounts to install big block 455 Buick into a Regal?

 

[mitchell.cox1]

Park lights

are they the ones for the bumper or next to the headlights? What price? Thanks

 

[MGTech30]

350, but a 455 uses the same motor mount positioning.

 

[MGTech30]

Bumper mounted ones. damn near perfect condition. $80 which is lower than I paid for them just to sell them. Shipping anywhere in the U.S. should be around 6-$10.

Thanks,
MGTech30

 

[Ken Adams]

V8 Frame Mounts

How about $16 shipped to zip 65101? MO acceptable?

 

[MGTech30]

The shipping could be as low as $6 but I'll charge you $16- sure! The total will be $96.00.

 

[Ken Adams]

350 455 Frame Mounts

Let's try this again, for the 350, 455 frame mounts, how about $13 for the mounts and $3 to ship to Zip 65101? MO acceptable?

 

[MGTech30]

Ohhh! Yes that's correct. LOL Sorry about that man I was replying to several ads today got it mixed up.

 

[xxTurboTxx]

How much for the accel wires?
also,do you have the a/c lines?

 

[MGTech30]

I'll take $45 for them. They are $67 new. I don't have '87 ac lines.

 

[captflash]

Windshield trim

Do you have any windshield trim in black? I would take all 3 pieces. Thanks.
Ross

 

[Squid4life]

"3 "6" cylinder power emblems (hot air intake), New double roller timing set, misc. '87 GN gaskets + Hi-Po cam bearing"

1. Pics/Price on the hot air intake emblems?
2. Who made the timing set? Brand/part #?
3. Pics/list of the gaskets?
4. Who made the cam bearings? TA? Part #?

Prices on each of the 4 above individually or as a group please.

 

[Hot Air]

2 black antennas FS

What did the antennas come off of. Interested! Price?
Conrad