|
 |
 |
 |
 |
 |
 |
 |
|
|||||||
|
Welcome to the TurboBuick.Com forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
September 3rd, 2007, 10:23 AM
|
||||
|
||||
|
Threaded shifter plunger
Guys, I'm installing one of these shifters and when I pressed my plunger down the steel threaded part is jamming where the plastic piece screws on and doesn't always want to come up.
 I have been able to free it up but it seems it's stuck now. I've shot WD-40 and white lithium down there to try and free it up too. Any ideas? I'm using a small screw driver to wiggle it and it did free it up before.  SHIFT HANDLE INSTALLATION INFO INCLUDED PARTS OK, I've taken the console out and noticed that the 1/16" plunger height is too much and forces the locking rectangle locking pin to go too far down and it gets out of it's slot. Here's a pic in a sec. 
__________________
My Web Site http://ca.geocities.com/mlvd@rogers.com/ 70 Z/28, 87 GN WTB: 70 SS396 Chevelle 4-spd, flapper hood car, no rag tops, Canadian car. Last edited by copo : September 3rd, 2007 at 11:04 AM.     
|
|
September 3rd, 2007, 12:07 PM
|
||||
|
||||
|
So I made the adjustment on the plunger height until it worked. So much for instructions. Car to car may differ.
__________________
My Web Site http://ca.geocities.com/mlvd@rogers.com/ 70 Z/28, 87 GN WTB: 70 SS396 Chevelle 4-spd, flapper hood car, no rag tops, Canadian car.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Threaded oil gallery plugs | CTX-SLPR | Engine Tech | 1 | February 27th, 2007 09:49 AM |
| plunger after the pump | volvoman | Alcohol, Nitrous and Propane Tech | 4 | April 28th, 2005 03:57 PM |
| ? on shimming new adjustable servo pin and bowtie overdrive tv plunger spring | 85monte | Transmission Talk | 2 | September 28th, 2003 09:31 AM |
| Can a too long TV plunger spring cause 2nd gear starts? | Nordbert | Transmission Talk | 5 | May 10th, 2003 07:22 PM |
| TV plunger spring | 85 Riviera | Transmission Talk | 3 | September 27th, 2002 07:17 AM |
Linear Mode
