Cooler mounting with FMIC???

Spl170s · #1 (**permalink**) March 26th, 2005, 02:36 AM

looking to see where you guys with FMIC are mounting your tranny coolers at.

pics would be helpful too if you got any!!

thanks!

boost86 · #2 (**permalink**) March 27th, 2005, 12:35 AM

I would like the same info anyone want to chime in

boost86 · #3 (**permalink**) March 28th, 2005, 07:24 PM

anyone????

GANGSTER · #4 (**permalink**) March 28th, 2005, 08:58 PM

I have a cottons fmic which id have to say is the biggest out there (quick plug for jack)and i still have room between the fmic and the a/c condenser for my b&m trans cooler. it can be done.
i made brackets to mount it but you can even buy the strap kits they make for trans coolers and mount it to your a/c condenser if you wanted.

RKturbo6 · #5 (**permalink**) March 28th, 2005, 11:05 PM

I just put a PTE FMIC on and with the AC condensor with the B/M trans cooler (there biggest race cooler) It was not even close to fitting between the condensor and the IC even with the IC's standoffs. Might have figured out a way to mount it over behind the Passenger headlight but already had alchy pump there. I finally decided to mount it under the car next to the tranny on the drivers side. I used spacers to stand it off the floor a little and allow air to pass over the top and bottom of it. Makes for a clean install and I would think works reall good. GL

WE4 · #6 (**permalink**) March 29th, 2005, 02:20 AM

I have the big PTE front mount IC. It is about 6 years old and was the largest at the time. I do not remember what model it is but it takes up every bit of the grill area. The tranny cooler is mounted to the bumper bolts in front with strap T-6061 Aluminum 3/16ths strap and the bacl is made with L bracketts that bolt into the radiator shelf support also T-6061 3/16ths Strap aluminum. All lines are #6 JIC Teflon stainless steel braided hose.

Only had one bad occassion and that was when I hit a rabbit one time. Broke the cooler off. Rabbit got the worse of it tho, dust, all that was left. Anyway, here is my WE4 install.

PICS

WE4 · #7 (**permalink**) March 29th, 2005, 02:22 AM

another view

WE4 · #8 (**permalink**) March 29th, 2005, 02:24 AM

one more

RKturbo6 · #9 (**permalink**) March 29th, 2005, 04:30 AM

Mannnnn, had to post the dead rabbit thing right after Easter!

Thank god I could not open the pics. Might have been tramatized seeing tranny cooler with a rabbits foot hanging on to it. Poor Bugs

Well I am fixing to get an F-body radiator and have to figure somewhere to mount an oil cooler. Will probably try to stick it in that area somewhere.

lazaris · #10 (**permalink**) March 29th, 2005, 11:35 AM

Bruce,

It wont alow me to veiw the page.

GANGSTER · #11 (**permalink**) March 29th, 2005, 12:31 PM

DO YOU FIND YOU HAVE BETTER LUCK WIHT THE RABBITS FEET CAUGHT IN YOUR TRANS COOLER?

WE4 · #12 (**permalink**) March 29th, 2005, 01:02 PM

directly through IE6 or netscape. sometimes aol and others will block the pic. If you want them sent to an email, email me and I will send as a zip file.
Bruce
WE4

chris · #13 (**permalink**) March 29th, 2005, 10:15 PM

Why can't I view these pictures? I get this message.

vBulletin Message

You do not have permission to access this page. This could be due to one of several reasons:
1. You do not have permission to access the page that you were trying to. Are you trying to edit someone else's post or trying to access administrative features? Check that you are allowed to perform this action in the Forum Rules.
2. If you are trying to post, the administrator may have disabled your account, or it may be awaiting activation.

Spl170s · #14 (**permalink**) March 29th, 2005, 11:19 PM

i get the same message you are?? can't see them either...what gives?

RKturbo6 · #15 (**permalink**) March 30th, 2005, 12:29 AM

Hey, maybe they were sensored for graphic violence because of that poor rabbit.

WE4 · #16 (**permalink**) March 30th, 2005, 01:11 PM

Quote:

Originally posted by Spl170s
i get the same message you are?? can't see them either...what gives?

And they all came up. It must be your settings on your pc or your ISP. Are you logged in when you are doing this? I am curious as to what is going on. You should be able to view. Try entering site off internet explorer 6 and log in with nothing else open. It should not be this hard. We are missing something. Let me know.
Sometimes Isp's have a blocker built into them so ck that also.

Bruce
WE4
Tb.com admin

broke1 · #17 (**permalink**) March 30th, 2005, 01:14 PM

I think only mods and admin can veiw pics not posted in the lounge..............Ive never been able to veiw any attachments not in the lounge from ANY computer.

2quiktocare · #18 (**permalink**) March 30th, 2005, 01:18 PM

I can view them at work and my home computer. It is more than likely in your own isp settings as Bruce mentioned.

broke1 · #19 (**permalink**) March 30th, 2005, 01:22 PM

Like I said,only mods and admin.Last I checked your name is in bold letters Mark

Firechicken · #20 (**permalink**) March 30th, 2005, 03:38 PM

The problem with seeing the pics aren't with ISP or on our end...it comes up as a vbulletin message generated by the forum itself. See a pic of the error we get at the link below:

http://www.magma.ca/~cdannehl/stuff/error.JPG

2quiktocare · #21 (**permalink**) March 30th, 2005, 07:25 PM

I tried under my private name as well broke, and it works as well.