I have a standard 109 block from a 66k mile car, crank is also std, rods are the 2 dot, also includes a nice dent free clean oil pan, crank and water pump pulleys, timing cover should be replaced, 8445 head that will need redone, lower intake that needs cleaning, green stripe injectors and fuel rail, headers and crossover pipe, flexplate, oil drain tube. local pick up in dfw tx. call greg 817 202 7258. The story on the engine is it is from the flood car i am parting out, 3 of the six pistons were very corroded which made the motor not turn over by hand. i disassembled the motor removed the pistons and left the crank installed. crank turns freely, motor was not ran since the flood so there is no scoring from the pistons moving in the cylinders. There was no ring ridge at the top of the cylinder so you may be able to get away with just a honing. Pistons are junk. Thanks Greg
Parting out the engine, intake is gone, i have almost every part for a complete engine, let me know what you need.
Here is what i have left with prices of parts individually and the bulk price if you buy all. 109 block std $300 standard turbo crank $250 2 dot rods $125 oil pan $50 very clean set of 8445 heads from the 85 hotair i parted with 6?k miles $100 flex plate $25 hot air valve covers very clean $75 I sold the 87 v/c for $100 Stock 87 turbo leaked oil no housing contact $100 87 stock t/b complete with sensors, needs cleaning $100 Total 1125 or 700 for all, this deal includes a good set of heads, valve covers, turbo, and t/b, the previous ad above did not include these things, If you dont need all of this then make me a reasonable offer on what you need. Greg 817 202 7258
