push lock vacuum lines

Good looking setups. I make blocks for different equipment here at work, both for vacuum and pressurized air. This is the first time ive seen it put to use for automotive.Great thread.

Can someone post the sizes to use (hoses and fittings) I can get them at work but we have standard and metric. I just want to get the right size. TIA

For cotton's block it was 1/8 NPT.

Go here Push In Fitting, Air Fittings - STC Fittings
for fittings, very reasonable and quick, will sell small amounts, in metal or plastic,

I have them at work. I need to no what size for the hoses that goes into the fitting. Thanks
Guys

thanks for the link.

Still waiting for tube sizes?

It depends on the size fittings you chose

Isn't already determined by the vacuum line size that is there. I mean I can't run a 3/8 line if the factory line is 1/8

Pressure is transmitted equally regardless of the line size.

Oh come on guys.

I know the thread size is 1/8 npt. What is the inside size of the fittings and hoses that you need to do a conversion?

send Znix a PM he has them on his car maybe he can measure them for you????

Mine are 1/4" (I think)motor is across town. And it really doesn't matter. The factory lines are tiny

Thanks if any one can conferm the sizes it would be great. We have many sizes at work standard and metric. Just want to get it right once

Yes thank you

How did you attach that fitting to your 3 bar? Also where are you buying your fittings and tubing?

Hey there! Where did you get that plenum spacer?