Fastest Stage II on alky

Discussion in 'Alcohol, Nitrous and Propane Tech' started by fatride, Feb 1, 2012.

  1. fatride Active Member

    Message Count:
    1,372
    Online
    I see the post about 109 motors, but who has the fastest Stage II running Alky? I'm stuck with my new project. E85 is slowly dissappearing and thinking of going back to alky on my OC S2 motor. Will alky/pump gas support the #'s to run high 8's?
  2. Haterade Adsense



  3. Grumpy Buick "RICER"

    Message Count:
    9,862
    Offline
    I thought there was one @ BG.. Maybe ran 9.4 but with low boost.. A silver T I think .. I forget where it was posted. High 8s ???? Dammmm. Ill be watching for your results :cool:
  4. Kip Member

    Message Count:
    851
    Online
    You are taling about Robert Wilson's car. He was at BG bracket racing in Super 16. I think he made it to the semi finals this year and the finals the year beforeat BG.

    Hpoe that helps, Kip
  5. tom robison ALL UP IN THEM GUTZ

    Message Count:
    718
    Offline
    It is true, you are still alive.
  6. Razor Forum tech Advisor

    Message Count:
    12,257
    Offline
    Yup.. Robert Wilson running 9.3's
    8's are possible. Just need to work up on the tuneup.

    My car just ran 9.04 at 153 on a 1.50 60ft. But its a Ford :/
  7. tom j Active Member

    Message Count:
    1,172
    Offline
    There are s2 running mid 9's sub 20psi so yes i think its easily possible
  8. HighPSI Moderator

    Message Count:
    3,846
    Offline
    Geno & Jim Rock have been 7's on alky and Turbodragster and Mike Booher were faster than them :)
  9. Kip Member

    Message Count:
    851
    Online
    Since the OP was asking a question about alky/pump gas are you saying these guys did it on alky/pump gas?

    Thanks, Kip
  10. fatride Active Member

    Message Count:
    1,372
    Online
    Thanks kip, and to eveyone who has replied! Anyway to do a direct port alky system?? I have a BMS tunnel ram..
  11. tom j Active Member

    Message Count:
    1,172
    Offline
    I would think that a direct inj system won't have enough atomization to cool the intake charge like with a normal nozzle setup.


Share This Page

^ Top