|
 |
 |
 |
 |
 |
 |
 |
|
|||||||
|
Welcome to the TurboBuick.Com forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
May 30th, 2006, 10:43 PM
|
||||
|
||||
|
rear view mirror
is there a way to get the metal part from the rear view mirror off the windshied with out breaking it?
__________________
84 gn/ 87 engine .030 109 ballanced, msd 50# inj, all billet mains, bms rods, 8445 champion ported heads, comp cams .459 lift, champion intake, precision fm, accufb 70mm tb, 340 fp hotwired, tt 93 chip, 3 in mcale dp, hooker cat back, northern alum rad, b&m tranny cooler. all on 93 octane...     
|
|
May 31st, 2006, 04:11 PM
|
|||
|
|||
|
You can scrape at the edge with a single edge razor blade. Try soaking it with acetone at the same time as this should help loosen the epoxy.
__________________
Eric Fisher OEM Parts Specialist at GBodyParts.com 252-332-8787 1997 SCCA Regional Champion. 1986 Grand National #38 ESP 86 Grand National 84 Riviera T-Type 82 Regal engineless
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
