If youre running a set of front and rear gta rims then you will need to do some switching. The rear gta rims will be used in front w a spacer. I...
Id say total the regal and take drivetrain. Youre not molesting it.if its a simple swap why not. Now if wanted to ditch ac etc then I wouldnt hack up...
Could also go w alradco dual fan kit. I recommend the extreme kit if you have a fmic or a stock intercooler. Aftermarket slic are too big to eun...
Exactly. I always felt if guys are asking buku dollars why are they advertising on craigslist to begin with. Then you got the ones with no pics.:D
That thing must be stupid loud.:D got my duals 3" just hangin and low rpm rumble is tough to bare. Could only imagine that. Idle must sound mean
I have those on the car now. Really made the car look tough.do ypu have a specific tire you want to run bc that will narrow down back spac8ng
Ive done it. Works verywell
I went w spohns qa1 adjustable coilovers and I couldnt have been happier. Theyre more expensive than shocks spring but cheaper than other coilovers..
Def could be fuel pump if it was just cranking.. fuep press guage would help even if its a temp..
W new turbo did u replace feed and drain line?
My turbo stop building boost when it needed a rebuild... no smoke no nothing. Stepped on gas n just fall flat on its face.. hopefully not turbo
Nope only thing left is to find a used one and or chrome yours out
Depends on chip but I think cars like min 38 psi w vac line off. You dont need a code reader theres a way to jump it out w a paperclip.. google it or...
I dont remember too much but it is enough. Its a little difficult because of space.....
I had that code come up on and off. If I remember correctly it was the harness going into the ign module under coil. I believe a white whire in...
I purchased the 3" dp and fotting it was easy and flawless. The hardest part was taking the old crap out!
i would bet 98% of the people want just bolt on fast goodies. Lucky for us our cars handle small mods well and our aftermarket parts make it easier....
Which ones to do first to stop this? Have similar problem w factory arms bushings etc. Not looking to trim or roll
I just installed an rjc 3" thdp style. Hardest part of the job was taking the old stuff out. Its def close but w elongated holes adjustment is easy....
Looks factory!
Separate names with a comma.