Nice aluminum VC's are hard to bet.
I installed everything and fired it up. Car seems to run great but the passenger side sounds like a drum solo going off inside the valve cover....
'm more worried about the ones that are kind of loose.
Guys, I installed another set of pushrods and on the driver side they all have a little resistance but still spin with my fingers. On the passenger...
Thank you sir.
How do you get there? I turned the motor until the intake valve just started to open and measured at that point. Also, the pushrods that I...
I'm about to measure the pushrod length and have a quick question. Does intake/exhaust valve need to be in any particular spot before I measure or...
Thank you sir. I'm going to dive into it tomorrow am and see if I can fix this turd.
I'd like to get some but I don't want to throw money at it and it not fix anything. Does anyone know if having the wrong length pushrod would...
Thanks for the tip. Do you notice alot of varience?
Thanks for all the help guys. Looks like I'll get a checker and figure out the proper length. Does the motor need to be a tdc when I do this or can...
Guys, I installed a roller cam a while back and the car ran like crap and popped under load. I pulled the pushrods out and they were 8.050. I...
The AF was at 7 The cc werecycling though so one second to the next they'd be very different.
L8--43 int--130 BL---139 ATS--101 TPS--46 IAC--57 We started the car and unplugged the cam sensor, it runs better at a low load but under heavier...
We've adjusted the cam sensor with the caspers tool and even went clock wise/counter clock wise until the car wouldn't start. It gets a little...
Will do Chuck. Thanks for the advice.
When we installed it we put the motor on tdc on compression stroke and the dots were lined up. We pulled the cam and timing set and reinstalled the...
We used caspers tool to get the cam sensor adjusted the first time. It doesn't pop at idle. Just when you start to rev the motor. When I drive...
Thanks Charlie, I needed this help. :)
Guys, I just installed my 212/206 weber cam and now I have popping and a miss if I stab the throttle. I read about advancing the cam sensor a...
Separate names with a comma.
