I would say the test with the fuel soaked sticks burned under the jars does not representative how each fuels burns. The ethanol would always pass...
This should help http://turbobuick.com/forums/threads/glovebox-lock-removal-video.387789/#post-3126148
Will be great seeing a couple of the cars on the Sound Performance dyno on April 12, 2013...
Both my turbo Regals now have a fixed antenna. The fixed antenna base has a mount on the inner fender and of course is secured through the fender...
Hi Jeremy send me your E-mail address and I will send a copy of the XFI file for the Daily
When pressing the reluctor to the harmonic balancer it should look something like this [img]
I would try bypassing the hot wire relay, I've had one go bad, thank goodness it was at the end of a run at the BPG Nationals in Columbus. Just plug...
Did you change the circuit breaker in PWR ACCY spot shown on the picture above? If you have get a volt meter and make sure there is 12 volts to...
[IMG] Petal from powermaster on left and standard petal from vacuum brakes on right. The pin is bigger in diameter and too high to use with a...
Here are some quick tests to see if the booster is working correctly [ATTACH] Hope this helps
[ATTACH] The relay for the power door locks is behind the computer in the passenger kick panel. The power for the switch side of the relay is...
I have compiled the A/F ratios discussed in this thread and put in a file comparing Lambda, and ratios for E-85 and Gasoline in their respective...
If it was just "rebuilt" take it back, for a refund. Cannot go wrong with a vacuum boosted system.
Tom Rix gave our Chapter a tech session in using four scales to balance a car. I would add weight over the right rear tire to off set the weight of...
The 120 lb injectors were maxing out at 5500 rpm and above when my second Walbro 340 fuel pump was not coming on. The second pump allows my...
After going through spammer fighting for many years we now ask those who want to join Chicagolandbuick dot ORG to E-mail us, in lieu of daily clean...
Hi Razor, am installing one of your older Alky Control units n a friend's GN who is color blind. The on light turning red to green cannot be...
Hi Rick Until a downloaded and installed C-Com software is connected to it's respective Classic or XFI box it is in demonstration mode and will...
Yes the red wire is the voltage sense wire that may be hot all the time and the white wire should be hot with power on and either wired through the...
Have you tested the exciter circuit. The 12 SI alternator in your car requires the circuit through your alternator idiot light to properly operate....
Separate names with a comma.
