you left me scratching my head. I believe this to be a advanced course in tuning. Is anyone putting on the class anyplace close to OKC? I understand...
I need a front bumper both parts off a GN black call me if you have one 405-361-5362
Behind your glove box torward the center of the car is a cable that switches your flaps from hot to cold also. you need to make sure the tab is not...
Line bore or your going to be doing this again and buying a crank
Take the engine out and do it. It is much easier. Or you can bring the car to me and I will have you back on the road less than 8 hours. I am a pro...
Elementary my dear watson
I found a bad ground to my engine block after replacing head gaskets. I must have not got it back tight.
I have a malfuntion code 34 coming up on my scanmaster and the car is bucking and jerking under a load but is not dying,its more like a loss of...
did you figure it out yet? coil and module was the problem with mine.
You should not have a issue. If your not to far into it you can take it back out and put another one in there but I have installed several that...
The seals your talking about yes picture 2 is correct and they offset them to keep the ends from seaping oil. always offset a rearmain seal or 2...
Try to get ahold of Billy anderson. He may know what your talking about. That looks like a odd cam to me.
It came from Full throttle. The hole was half the size of the one I removed.
I also had a question on a timing cover. I bought a new one and new oil pump and was told to machine the hole in the cover. I am assuming it is the...
Arp says 120#'s using oil on the threads of there studs.I am using there studs at 130 with oil. I am using there rod bolts with oil at 55#'s. Just...
I wanted to know if there are any buick members near this address 1046N huron RD linwood mi 48634 . If so I need your help. you can reach me at...
anyone know the torque on these bad boys off hand? I have looked on here high and low and cant find it.
Installed the rear main seal and using oil on threads so 130ft lbs on the torque
Yes I know to stagger the seal I just forgot which way it goes. Thanks. what about arp main studd torque?
[ATTACH][ATTACH] Which picture is correct? It has been a while and I cannot find my manual. The damn directions on the box are not very clear.both...
Separate names with a comma.
