|
 |
 |
 |
 |
 |
 |
 |
|
|||||||
|
Welcome to the TurboBuick.Com forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
September 23rd, 2006, 01:14 PM
|
|||
|
|||
|
where plug the scanmaster
hi , do i have a way to instal my scanmaster direct on the ecu ! not on the plug under the dash! thanks bob
__________________
stage 11 gn 280ci ,fast b2b,gn1r heads,jw trany,160 inj,cotton fmic and more !  gn t-top 87 109 block,eagle rods,j&e forge piston,arp bolt and stud,rjc gardle,pt70gtq ball bearing turbo,72 inj,hot wires ,gn1 iron head,weldon fuel pump,alky kit by julio don,atr 3"down pipe,hoocker exaust,ta headers picks at: http://tybob.monchar.com/     
|
|
September 26th, 2006, 08:55 AM
|
||||
|
||||
|
Yes there is.
According to the ECM wiring diagram at: http://gnttype.org/techarea/ecmsensors/regal_ecm.jpg The signal wire is located at Pin A8, on the smaller of the 2 connectors and should be an orange wire. This is the way I have mine connected as well.
__________________
Mike Yrenaya '87 Turbo-T Limited
|
|
September 26th, 2006, 01:14 PM
|
|||
|
|||
|
heheh thanks i will try today
 
__________________
stage 11 gn 280ci ,fast b2b,gn1r heads,jw trany,160 inj,cotton fmic and more ! gn t-top 87 109 block,eagle rods,j&e forge piston,arp bolt and stud,rjc gardle,pt70gtq ball bearing turbo,72 inj,hot wires ,gn1 iron head,weldon fuel pump,alky kit by julio don,atr 3"down pipe,hoocker exaust,ta headers picks at: http://tybob.monchar.com/
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
