|
 |
 |
 |
 |
 |
 |
 |
|
|||||||
|
Welcome to the TurboBuick.Com forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
September 4th, 2004, 07:42 PM
|
|||
|
|||
|
TL stopped recording boost.
My TL stopped recording accurate boost. During one run it showed 5.0 and my aftermarket in-car gauge showed 23. On other runs it showed 8.8 and 7.8 when the aftermarket in-car boost gauge was showing 20 (I turned it down) . I am running the boost harness and Extender chip. I have the parameter setting at Scanmaster W + boost + Extender. This is the setting that I have always used and it has always recorded boost. Any suggestions? Thanks.
__________________
Jim: 87 GN with: TE-61/PTE .63 housing - ported stock heads - Erson 208 cam - Speed Pro forged pistons - PTS trans. & 9/11 converter - MSD 60# - CAS V-4 - 3" DP - ATR 2.5" exhaust - 62 JJ TB/stock plenum - RJC power plate - Gen II w/LS-1 MAF/PL - SMC progressive alcohol - Walbro 340 - and Extender G chip with 26*/22* timing. Best 1/8 mile run: 6.904 @ 100.04 with 1.535 60'.     
|
|
September 4th, 2004, 08:40 PM
|
|||
|
|||
|
Forgot to add this. I changed from the Turbotweak chip to the Extender. Does TL need to be set to Scanmaster Y or Z, instead of W for the fast update Extender chip?
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
