|
 |
 |
 |
 |
 |
 |
 |
|
|||||||
|
Welcome to the TurboBuick.Com forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
August 1st, 2004, 10:22 PM
|
|||
|
|||
|
Innovate LM1 gone nutty.......
I accidentally unplugged the sensor from the control unit and after that it is not reading right. I plugged it in, calibrated the sensor and heater.
What it is doing is displaying implausible A/R readings in the 20.x to 30.x to 1 with the "bar" display acting erratically. Instead of full blocks increasing and decreasing, it flickers kindof. Has anyone else seen this? I have not used this with leaded yet, and it has not been used more than 500 miles. I am probably going to try a new sensor, but if anyone has a good guess I am all ears.
__________________
Silent but Violent     
|
|
August 2nd, 2004, 10:39 AM
|
|||
|
|||
|
I haven't seen this, but a good place to ask is Innovate's forum on their web site. Klaus (the designer) usually answers questions within a few hours - great customer service. Also, have you downloaded the logworks package with version 1.4 of the firmware? Logworks is verrrrrry nice :-).
__________________
Regards, Carl Ijames carl.ijames@verizon.net
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
