|
 |
 |
 |
 |
 |
 |
 |
|
|||||||
|
Welcome to the TurboBuick.Com forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
September 19th, 2003, 09:33 PM
|
|||
|
|
|||
Just installed DFI!
Having problems-->>Car starts,rpms climb to 2200rpm and slowly come down to 1000 rpm and shuts off.
Everything ran fine before install and i will not have a laptop untill tomorrow. Any ideas?     
|
|
September 19th, 2003, 09:44 PM
|
|||
|
|||
Wait until you have the laptop tomorrow.
Which version DFI is it? The current DFI Gen 7+? ------------------------------------- All will go smooth & quick for you tomorrow, with the laptop. 
__________________
Happy to participate, and thanks! __________________ Help Stomp Out Customer Abuse! ----------------------------- Ripped Off? Here's Helpful Info: http://www.fraud.org/info/contactnfic.htm http://www.ftc.gov/bcp/conline/pubs/buspubs/mailorder.htm
|
|
September 20th, 2003, 01:32 AM
|
|||
|
|
|||
|
It is older DFI gn 6.
I got it running,but when i put it in drive it stalls........i will figure it out! I need a good source for an EGT gauge,anyone know of one? Mike. Last edited by BigChinooks : September 20th, 2003 at 03:29 AM.
|
|
September 20th, 2003, 06:07 PM
|
||||
|
||||
|
I would guess that the IAC is set to open way up on startup, and as it closes once the vehicle fires, you get into an area of the map that doesn't have enough fuel to keep the engine running properly. Richen the idle area and see if it stays running.
|
|
September 21st, 2003, 04:02 AM
|
|||
|
|
|||
|
I got it sorted out!
Thanks for the replies.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
