Looking To Trade For Some Parts

[TURBOELKY]

here is what i have to trade.
built 350 tranny. shift kit, b&m pan, 2600 stall converter. 1k miles.
t-type wheels from my 87 we-4, no caps no tires.
radiator support from we-4 perfect condition.
cragar sst wheels with new dunlops. 14x7 front,15x8 rears. fit gn perfect.
also have grey arm rests for lower door panels, and grey a pillar peices.
stock turbo, perfect condition. no shaft play, on car now.
rear we-4 seat. perfect foam,never really sat on,just dirty, a little.
stock drive shaft from we-4
stock injectors fron gn.
here is what i am looking for
adj. fuel pressure regulator
adj.waste gate actuator.
INJECTORS!!! 45'S AND UP
and of course, an aftermarket turbo... i'm willing to trade, or sell this stuff
but i really need above mentioned items. thanks jerms_22@hotmail.com

[buickbert]

very interested in wheels, can i get some pics to twint66s@yahoo.com?
how much are you looking to get for them shipped to tucson,az 85730? any curb rash or dents in them?

please put me first in line for these wheels.

thx
buickbert

[TURBOELKY]

Which Wheels, I Posted Two Sets. Thanks For The Interest, Get Back To Me, I Have Pics.

[jdpolzin]

Is the drivers side A piller piece in good shape? If so, I'll take it from ya. Also I will be selling my TA-49, 50# inj, and 4 position Turbo Tweak chip. Give me an e-mail to jdpolzin@yahoo.com. -----Jeremy

[jdpolzin]

I will also probably have an adjustable fuel regulator. I'll figure out a total package price if you want everything. Let me know!! ----Jeremy

[TURBOELKY]

YEAH MY DRIVERS SIDE SHOULD BE MINT. LET ME KNOW IF YOU WOULD TRADE SOME OF MY STUFF PLUS CASH FOR YOUR INJECTORS. ALSO LET ME KNOW ABOUT YOUR TURBO, BUT I'M LOOKING INTO GETTING A CHIP FOR MY SPECIFIC NEEDS MADE.I REALLY NEED INJECTORS AND A FUNCTIONABLE ADJ. FUEL REG. YOU CAN CALL ME OR EMAIL ME TO LET ME KNOW AHEAD OF TIME BEFORE YOU SELL ON THE BOARDS. jerms_22@hotmail.com or 310 902 4859. or email me your number, i'll call

[jdpolzin]

I will keep you informed!! How much do you want for the A piller piece? I can Paypal you the cash if it's a good price. What turbo and set-up are you looking to go with? I am basically putting my car back to stock. My car should run high 11's with the set-up I have now. The guy I bought the car from is going to be coming over this week so if he has time to give me a hand, we might be able to get most the pats off the car and running again so the mods should be able to be sold. If he doesn't have time to help me out, I probably wont be able get the pats off the car before it goes in for paint. I'll keep informed!! ------Jeremy

[TURBOELKY]

man, i dont know how much for the pillar peice. 5? plus shipping. i dont have pay pal though, money orders is usually how i sell my stuff, dont worry, i;m far from a theif. keep me informed on the injectors especially though.as far as the set up i'm looking to put in my car, i dont know, as long as the fuel injectors are big enough to cover the alky, and i can boost 19-22 lbs. and a bigger intercooler, i'll be happy, my el camino is a little lighter than the gn was, so i already have an advantage. keep me posted on the stuff, also shoot me an email of the price you will want for the stuff. thanks man.turbo etc.

[buickbert]

the we-4/ t-type wheels. can i get some pics to twint66s@yahoo.com?
how much were you thinking shipped to tucson,az 85730?

thx
buickbert

[TURBOELKY]

I Dont Have Pics On Hand, But Can Get Some Soon, But I Would Have To Get Back To You On The Shipping, Unless You Figure It Out With Dhl Or Fed Ex Online. I'll Get Pics Asap

[buickbert]

how much do they weigh each? my gn wheel cost $15 to ship from texas, and the other two i bought from mass were $25 each. the t-type wheels are lighter then the gn wheels so i would say since they are lighter and closer then the one i got from texas, they would be no more then $15 to ship each.
so that would be around $60 to ship from la to tucson. get back to me ( via email) with pics and how much you are looking to get on your end for them.

twint66s@yahoo.com

thx
buickbert

[YouLikeThat]

How big of turbo do you want? I'm going to be pulling off my GT32 in about a month or so. I'm going to a front mount IC,stall and a bigger turbo.
Thanks

[jdpolzin]

So far, I have a TA49 for $400, Kenn Bell Big Boy front mount intercooler that will come with dual fans for $600, Greddy Profec B Spec 2 electronic boost controller for $225, not sure on the 50's but will probably want to sell them with the Turbotweak 4 way chip. The chip is programmed for the set up at 93 or 110 and has a theft deturrent device also. My car runs at up to 24 lbs of boost with the 110 and is set at 19-20 with 93. I also have an audible knock sensor. Will need a stock intercooler with shroud that I will take on trade with the a-pillar piece also. -----Jeremy

[TURBOELKY]

Originally Posted by buickbert

how much do they weigh each? my gn wheel cost $15 to ship from texas, and the other two i bought from mass were $25 each. the t-type wheels are lighter then the gn wheels so i would say since they are lighter and closer then the one i got from texas, they would be no more then $15 to ship each.
so that would be around $60 to ship from la to tucson. get back to me ( via email) with pics and how much you are looking to get on your end for them.

twint66s@yahoo.com

thx
buickbert

i think i wanted 125 for all four right? i will post pics if you dont mind waiting until sat. night or sun. since they are at my mother in laws house 40 miles away, and i have a tight schedule, maybe sooner depending if i have to stop by there this week. i will get the shipping quote then. hope you dont mind the wait, thanks again.

[TURBOELKY]

Originally Posted by jdpolzin

So far, I have a TA49 for $400, Kenn Bell Big Boy front mount intercooler that will come with dual fans for $600, Greddy Profec B Spec 2 electronic boost controller for $225, not sure on the 50's but will probably want to sell them with the Turbotweak 4 way chip. The chip is programmed for the set up at 93 or 110 and has a theft deturrent device also. My car runs at up to 24 lbs of boost with the 110 and is set at 19-20 with 93. I also have an audible knock sensor. Will need a stock intercooler with shroud that I will take on trade with the a-pillar piece also. -----Jeremy

what would you like to trade for the intercooler and a pillar peice, i can round one up. i really want the injectors, but not the chip, 91 is all they have at the pump in Los Angeles, unless i stop by beverly hills where the ferrari's fill up!!! let me know if we can work that out, bye the way, how big is a ta 49 compared to stock? pics?

[TURBOELKY]

Originally Posted by YouLikeThat

How big of turbo do you want? I'm going to be pulling off my GT32 in about a month or so. I'm going to a front mount IC,stall and a bigger turbo.
Thanks

i dont know what a gt 32 is, pics? would you be interested in trading? or what would be the price. thanks

[buickbert]

no problem, no big rush. just get me the pics when you can. if they are in good shape, you got yourself a deal at $125+shipping. guess we will have to wait til then.

thx for the reply
buickbert

[YouLikeThat]

The GT32 replaces the TA49. I think it's rated to 520hp. I'm not sure what it's worth but new ones are 800 bucks (mine has just a couple hundred miles on it).
I want to get the car dialed in before I sell it, so if you can wait you should know what it can do.

[my85grandnation]

If you still have the drivers side a pilar I will give you $10 shipped for it.

[jdpolzin]

TurboElky, I will take the A-pillar piece from ya. The inner cooler and turbo are probably already spoken for. If not I'll let you know ASAP. I will go ahead and Paypal ya the cash for the A-pillar piece if you want to do it that way. Send me an e-mail and let me kow what works best for you. jdpolzin@yahoo.com. I am boosting up to 24#'s with the 49. It is a good stock appearing turbo. As far as the 50's go, I will probably wait and think that one out. I will keep you informed on that one. Send me an e-mail and we can work it out more privately!! thanks man!! -----Jeremy