|
 |
 |
 |
 |
 |
 |
 |
|
|||||||
|
Welcome to the TurboBuick.Com forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
March 30th, 2005, 09:21 PM
|
|||
|
|||
|
Question about ALDL Connector
Maybe a dumb question, but I've gotta 84 GN, engine is an '86-'87 Intercooled.
I haven't checked my codes yet on the car, but I plan on this weekend. Since my ECM was changed out to work with the newer engine, should I still be able to test for codes through the ALDL connector?
__________________
heh.     
|
|
March 30th, 2005, 10:36 PM
|
|||
|
|||
|
i have the same setup.....84with 87 motor....i can still pull codes though the connector, but i dont know if yours was set up the same way, i would assume it is...why not just try and see?
|
|
March 30th, 2005, 11:18 PM
|
|||
|
|||
|
I will friday when i get home, thanks!
__________________
heh.
|
|
March 31st, 2005, 10:42 PM
|
||||
|
||||
|
the upper left 2 ports on the aldl are the a and b take a piece of wire and jump these and look at the engine light blinking if there is only a 12 then there is no codes.
__________________
84 gn/ 87 engine .030 109 ballanced, gt52 25#, msd 50# inj, all billet mains, bms rods, 8445 champion ported heads, comp cams .459 lift, champion intake, precision fm, accufb 70mm tb, 340 fp hotwired, tt 93 chip, 3 in mcale dp, hooker cat back, northern alum rad, b&m tranny cooler. all on 93 octane...
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
