|
 |
 |
 |
 |
 |
 |
 |
|
|||||||
|
Welcome to the TurboBuick.Com forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
January 18th, 2005, 02:57 PM
|
|||
|
|||
|
how many pounds?
im wondering how many pounds should i leave at before it starts doing damage? i leave at 6 right now. also does anyone have any plans on how to make a drive shaft loop? thanks jerrad
__________________
87 turbo t: TE44, razors alky kit at 24#s, k&n 9 inch filter, 009 injectors, rjc power plate, exhaust with test pipe, 3 inch DP, turbo tweak chip, new valve springs, fuel pump, and hot wire kit. Last edited by jerrad : January 18th, 2005 at 03:06 PM.     
|
|
January 19th, 2005, 08:55 AM
|
|||
|
|||
|
Not sure when damage may occur - probably at any time at any boost launch level - I leave at 12# with no issues - yet.
I got my drive shaft loop from Postons for under $30.00.
__________________
Royal Foster Littleton, CO. Orig owner '86GN. TE-44, THDP, MSD 50's, Thunder Fab I/C 11.47 @ 117.7 At 5800'
|
|
January 24th, 2005, 01:46 PM
|
||||
|
||||
|
For my car, launching with anything less than 10#'s is a wasted run......
__________________
Geoff '87 GN -Stock Longblock, TA-49/Garrett housing, CAS V4-R, MSD 50#'s, 16 Pos MaxEffort, 3" DP/Ported stock elbow, Translator & 3.5" LS-1 MAF, PTS Extreme 9/11, Trans by Len Freeman, RJC Power Plate, SMC Alky. On Vacuum Brakes Since 1996!  11.78@113.59 1.63 60''85 WH-1 T-Type -GT67, PTE FM, GN-1's, 75 Delphi's, MaxEffort-R, 3.5" THDP, 3" Single Shot.... 11.31@117.82'87 GN "TURBO6" - Mostly stock.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
