|
 |
 |
 |
 |
 |
 |
 |
|
|||||||
|
Welcome to the TurboBuick.Com forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
March 11th, 2002, 07:51 PM
|
||||
|
||||
|
install pics
I found some pics of 2 installs I did back in '92. Don't laugh cuz they are "old school"!
__________________
ITSA V6/87 T-Type,aquamarine,130k miles,stk turbo&IC,gutted cat and 2 'stang flowmasters,14in K&N,RA93 chip(stk inj),Best ET-7.9@85.96mph 1/8(12.30's in 1/4) on BFG DR-1.75 60ft @1psi launch-20psi run(1/8mi). New combo-Killer Street&3000 9X11,billet capped short block,forged pistons, balanced,ported big valve heads,206 roller,1.6 roller rockers,TE61 turbo,stock ic,55#inj. New times here-7.61@87 1/8 w/17#(Best mph=89)! Race gas/chip next! http://sogaturbobuicks.4t.com/ 
    
|
|
March 11th, 2002, 08:22 PM
|
||||
|
||||
|
Re: install pics
Quote:
. I miss those days!
__________________
1986 Buick Grandnational MODS: 17" x 8" Billit Centerline "Champ 800's" wrapped in 225/45 Nitto 450s, Bell Tech 2" dropped front spindles, High flow cat/dual 2.5" diameter mandrel bent pipes and Flowmaster Delta Flows with dumps in front of rear axle, '87 GN grille, Polished aluminum mass air flow pipe with K&N on a 150,000 plus mile stock unopened motor.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
