|
 |
 |
 |
 |
 |
 |
 |
|
|||||||
|
Welcome to the TurboBuick.Com forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
October 31st, 2003, 08:41 PM
|
|||
|
|||
|
87 GN Radio Bezel Removal
Quick and easy question- I am going to pull the factory radio out of my GN and want to make sure I am right before I break the bezel. Does it just pull right off? Also I bought a later model harness for a newer GM radio, anyone updated their radios and if so any tricks?
__________________
87 GN TE-44, 009 injectors, Kenne Bell adjust F/P regulator and Cold Air kit, 3" downpipe and Hooker exhaust, 95 Riviera CD player, Scanmaster, Comp Cams Valve Springs, LT1 Starter, Ramchargers dual fan setup,Nitto 555 Extreme Drag radials and a tank full of 112 race fuel. Dyno Results: RWHP 328.6 Torque 460.2 *2007 Jeep Grand Cherokee Overland...yeah it's got a hemi! *2005 Chevy Tahoe Z-71 Me fail English?? That's unpossible.-Ralph Wigham     
|
|
October 31st, 2003, 09:50 PM
|
|||
|
|||
|
yea, the bezel just pops off. as far as the adapter you got, not sure if youll be able to use it or not.
__________________
87 turbo t, new engine 40 over,delphi 50s,jim testa chip, ta 60 ,esp front mount, dynotech trans, protorque 10 inch converter, terry houston down pipe, 2 and a half hooker exhaust, ported plenum,power plate , ,champion ported irons and ported intake, razors progressive alky, best et{11.688 at 117 0n pump gas }
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
