|
 |
 |
 |
 |
 |
 |
 |
|
|||||||
|
Welcome to the TurboBuick.Com forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
August 12th, 2001, 03:08 PM
|
|||
|
|||
|
installing kickpanel pods??
Does there have to be some sort of protective material put between the kickpanel computer cover and the back of the kickpanel pod to protect the computer from the speaker magnet??
__________________
87 GN: 3rd Owner, all papers since car was born. Stock engine and trans, 50lb injectors, PTE SS intercooler, 100lb valve springs, and the rest of your usual mods. http://<br /> http://community.webs...87gnblackdemon http://members.sounddomain.com/blackdemon87gn     
|
|
August 12th, 2001, 10:48 PM
|
||||
|
||||
|
All the kickpanels that I have seen, you have to relocate computer. You can put computer up into dash behind glove box or you can get an extension from Casper's to relocate computer under passanger seat.
__________________
1986 Buick Grandnational MODS: 17" x 8" Billit Centerline "Champ 800's" wrapped in 225/45 Nitto 450s, Bell Tech 2" dropped front spindles, High flow cat/dual 2.5" diameter mandrel bent pipes and Flowmaster Delta Flows with dumps in front of rear axle, '87 GN grille, Polished aluminum mass air flow pipe with K&N on a 150,000 plus mile stock unopened motor.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
