- Ductile roller, chime in
- please help me I.D this connector
- fitting size??
- Broken flange on block...
- 3.8 or 4.1???
- Engine light comes on, scanmaster goes dead.....
- 10's with the stock MAF...
- spark plug gapping
- ? Red light under steering column ?
- 3 way check valve # behind coil pack.
- Cam sensor failure code
- stock chip ID
- Help Please!
- thoughts on atr exhaust
- White wire to power antenna?
- cometic gasket
- smoke after getting into the boost
- thoughts on hooker exhaust
- Oil leak by dampner
- Oil Pump: High volume or not?
- Timing Chain?
- Brake line
- Trans. cooler fittings??
- F-Body Radiator?
- 3.5 Thdp??
- Ok, my Optima Deep Cycle battery is sizzling!!!
- Low o2 reading W.O.T.
- Much needed answer (steering column)
- V.P fuels- CSP
- 0->65->0 log
- Whats the average GN weight?
- Sticky Roller Lifters
- Just bought a GN, need some help
- Fuel pump install, one minor problem
- Combinations
- Main bearing clearance...
- code 23 and long time to start
- Gauge cluster
- How to set Boost w/ TH DP?
- Who burns the chips with the Smilie face sticker?
- part number for gm coil pack and iginition module
- broken body mount nuts, what now?
- how to tune?
- plenum/throttle body
- Weldom 2035????
- Door handles
- Mobil 1 synthetic oil 15w-50 race oil
- my dyno numbers
- Line Bore VS Line Hone
- question about the casper knock gauge
- crankshaft position sensor and oil pressure
- question?
- lots of knock
- Eagle crank? Clearance?
- need rod and main bearing info
- What FP & WG setting?
- LS1 vs. Map
- thoughts on BOV's
- need help?????
- Extender installation
- Whats your experience with pump gas?
- Monte Carlo Gauges?
- I dont want to break anything
- This may be a dumb question, but
- What Flywheel are you using?
- 3.5" downpipe
- Time for new injectors?
- Trans+ w/Extender Settings verification
- Poston cross over pipe question
- Rattle in motor
- Code 42
- is it my cam sensor thats bad
- ? On Engine Balancing......
- Still not sure if 60's will do it...
- How to identify 7.5" rear from the outside?
- Factory tach went whack
- Noise When Letting Off
- opinions please (be nice)
- Is the 4.1 worth doing??
- stock o2 sensors and data acquision systems
- Stock Block With Girtle ?
- engine build up questions.
- Basic BLM 's
- source of my interior water leak?
- block casting
- Greetings, new to the board and would like some opinions and suggestion for my 87 GN
- Roller rockers and valve cover gaskets
- Best Pistons to Use
- Error Code Question
- New here
- loud noise when the car running
- Pushrod size with roller cam and 1.65 rockers
- Help, Gn does not like to run cold...
- T&D's with stock valve covers
- minimum size of return line
- GNX fuel gauge - NEED HELP
- A/C question cracked/broken cover
- getting my car running after sitting in storage
- Boost, fuel, and EGT tuning questions
- Best way to fix hole in gas tank...
- just installed rear main seal,have a ????
- Rounded a headbolt @~60ft lbs, what do do?
- richard lee gate info?
- voltage drop when starting
- Turn Signal Trouble
- Exhaust: Cat won't fit TH downpipe
- Relay help!!
- Ground strap location?
- fuel pressure for the right combo
- What kind of epoxy can be used on cylinder heads?
- will not fit !!!!
- ATR Rear Sway Bar Creaking
- Anyone Heard Of This Starter??
- injector sizes
- Q Boost install question
- Coolant color
- What's the Skinney on Adj push rods ??
- gn not starting
- rod bearing failure 2 times
- JE pistons rings
- Type II Coil Firing Order
- loud grinding noise
- Ignition? Ecu? Troubles '85 Riv T
- what car
- Need gasket help
- Lock switches
- Double Pumper Fuel Pumps
- code 42
- anyone use a test pipe w electric dump
- no rosion
- Turbo Saver and Oil Feed line
- horrible bogging
- dip switches
- Valvetrain Noise
- Anyone using ACCEL HI-output ciol pack?
- Where to find THE 4.1?
- Is my TCC working?
- running rich at wot why?
- Wolf's Rear Sway Bar
- new dp bad idle
- cfm rating
- RE: Turn signal lever Question
- Fuel Return Line swap
- cross referencing 109 block casting
- coil and module
- Production vs Stage Lifters???
- Cam Breakage
- Cams??????????
- Wiring mess and disconnected connectors
- I've got a no start (power problems)
- Please help ID these Pistons
- best valve springs
- My setup & my intro
- To C clip, or not to C clip?
- Heater hose size?
- replacement of map sensor line
- Need size info on thermostats!!
- How difficult to replace fuel lines?
- Power lock relay
- how do you get the stock front sway bar off
- valve springs
- mandrel bends up to 8in o.d stainless or aluminum
- Interior grey color code ???
- Accufab plenums - are they worth it??
- valve locks and increased seat pressures
- 275/50-15 - Who is interested?
- shortblock
- 2 5/8" guage pod
- Heavy Duty U - joints
- Difference between 3" or 2.5" dual exhaust
- question about regal winshield wiper motor.
- New engine - what oil for break-in
- Cold idle issue.
- 2 sensors on the manifold???
- steering column
- Ls1 Maf?
- Coolant additive that creates bubbles???
- engine mount ?
- cold idle
- Pro Fab 3" Exhaust
- roller valve springs
- Alternators.....
- lt1/ls1/Ford lifters
- To CAM or NOT to cam
- calpak
- MAF Question
- ATR 3'' dual exhaust
- Fuel system blues
- 26918 Valve Springs Question
- what will happen if you?
- no start
- inner fender
- leaning problem
- Fuel problem- Help!
- cold idle
- A few questions
- Side Exhaust exit ?
- Boost Pressure Port
- Anyone with a 4.1 or higher than stock compression, I've got a question.
- Got it fixed!!!
- Naxflows or Race Magnums
- Hooker Max Flows or welded magnums??? Whats best sound?? No straight pipes!!
- Exhaust question
- Plenum spacer?
- Anyone try building a gauge-cluster?
- Question for RJC power plate users
- Who has the best price on Denso 02 sensors ?
- Fuel Pump Assembly
- info on comp cams roller cams
- Who sells line locks WITH fittings included?
- T-top weatherstriping
- Anyone running a Lunati cam?
- wierd whining
- Mease SS Down Pipe
- camshaft sensor
- strange canister
- couldnt do a front end aligment
- hot wire problem
- AFPR adjustments
- Powdercoating on the inside
- 170 psi in 1/3/5? 0 psi in #2.
- cooling system questions
- Injectors
- cat removal
- Tail lights??
- fueling prob...with double pumper
- gn1 heads question
- Who Sells The Updated Camshafts?
- What's the highest psi you can hold on the Foot Brake?
- A/C delete
- Fuel Efficiency
- Vehicle speed sensor
- Double pumper Q?
- which is the reason my maf is 255 @ wot now
- Acceptable "blow-by" numbers
- Chattering noise...still
- Turbo saver filter
- trunk lid
- where to buy a trunk kit???
- 10.64@127 on a truly stock bottom end
- head gasket ? retorque sequence??? help
- Should my FP drop like this?
- Soft Touch -> DIS
- Car won't sart
- Stupid IAC question from a noob
- How strong are the stock axles?
- QuickSiver Shifter Install
- Asto Roof
- engine numbers ????
- Coolant cross over modification.