- Need Help.
- Trans brake??
- Valve Covers Bolts
- 86-87 engine pictures-diagrams.
- looking for a pic of BUICK Diamond pistons
- How to identify an 86 or 87 Turbo Buick motor
- Strange knock with boost?
- Found a motor, I HAVE QUESTIONS
- 62 mm Throttle Body
- Oil Leak and Fix
- Quick Fan Question
- 13 psi
- T-top Weatherstripping install
- Gains with Aluminum heads W/TA 49
- Walbro 340 Fuel Sock
- Code 42 22 and rich O2
- Fuel pump install problem
- Cam Sensor
- Front Brace install with After Market Intercooler
- i just had my car DYNO in BROOKLYN NY
- When converting a regular Regal....
- Hood Mounted Fuel Pressure Guage
- headers and dump pipi
- Question about a 1987 Turbo T Limited?
- GN 1 valve covers help
- GNTTYPE is BACK!
- Newbie Boost Spike Q
- Which plug wires?
- Yet another MAFTPro question
- 210/215 Austemper Roller Cam & Valve Train Noise
- Idle hunting and shut-off after rebuild
- Shakes and rattles.
- Need Help
- which IC is better, SL or SFMIC?
- 84/85gn block & 4.1 #291 block
- fuel injector size
- Apr head bolt torque?
- is my steering column repairable?
- headliner question.
- crank position sensor noise???
- uncontrollable fuel pressure
- oil leak
- Question about TPS @ WOT
- ARP main stud part # for 4.1
- Weather Stripping
- Clevite "H" series main bearings?
- Electrical problems
- Dura-Bond cam bearings for 4.1
- ? on re-installing the cam sensor
- how long are the top header bolts (stock)
- T-Top Weatherstrip
- Pre load for 212/212 roller
- Compression test questions
- Seat Belt Question
- best place to get an ignition module
- Shorter IAC connector?
- Color Question
- scanmaster directions??
- Egt Meter Question/problem
- anyone have Double Pumper directions??
- Air + Fuel Ratio with Scanmaster
- Fuel Gauge
- kbb values....
- BstC Light?
- Rear Main Seal
- ATR Ram Air Help
- Help! Water Waping, Fresh Motor
- Piston ring suggestions for 4.1?
- Main bearings
- What to do?
- Radiator
- Gas cap causing vacuum leak?
- 86-87 turbo-exhaust gasket.
- oil leak
- Does the oil bypass spring affect oil PSI?
- oil drain tube size
- Higher EGT's...but nothing changed on car
- K&N filter maintance
- A.c.
- cold air
- Lockup converter?
- Need advice on buildup.
- a/c heater delete question.
- Blew it up!!!
- Header and Crossover Question
- Broken balancer and maybe messed up crank nose with pictures :( sugestions please..
- Really need help.
- Best headliner adhesive
- boost leak
- Questions about ignition parts...
- I have the error 42 plague
- oil pump pickup ?
- Blow off Valve
- Upholstery Dye (sp?)
- Turbolink (need Info)
- longer water pump shaft replacment?
- Which are better 85# MSD/Holly or 83# Siemens Injectors????
- Need Help
- 3.5down pipe with atr headers & a/c?
- need to find polished vacum mastercylinder
- Where can i buy a waste gate for my 85
- Cam Sensor Removal
- electronic touch climate control
- Anybody put a 30 spine posi in their cars....
- oil feed
- Tach installation ? and ? about plug wires
- Hmm, Magnafuel fuel pumps?
- spark plug wires
- oil pressure line
- Where can I get new wheel studs
- Draining the fuel
- What gains should I see with this combo?
- Who sells aluminum bumper brackets?
- Torque value for DP to stock turbo elbow?
- Where to get CAS intercoolers?
- Down Pipe Famine
- Loosing 12v ign during cranking
- T-Top to Hard Top
- Continued knock diagnosis...
- FMI for street use only question
- no lights anywhere
- Head Gasket specs on LC2?
- School Me
- Door keys...I need them...where to get them
- Please help me identify this part
- new turbo owner
- translator+/good or no good with heated o2?
- Putting driveshaft back in?
- turbo tweak
- oil return line
- whats wrong with this thing?
- Coil Pak
- Stroker crank and Z1 Rods in 109 block - first try
- How Much Does A Te 60 Weigh ????
- Coolent all over the place
- Stock head gaskets
- Sheet Metal Valve Covers Scam Seller
- RJC intercoolers new polished pipes
- XR3 roller cam
- Call me stupid... just making sure!
- plug wires
- Beginning Mods for New Guy
- Factory astro new seal
- your opinion on this gnx clone?
- your opinion on this gnx clone?
- Trunk Sticker Codes
- Is This Alright To Use?
- powder coating
- Dash Problems
- How to test wastegate solenoid?
- Running rich cam sensor or tps?
- fuel pump question
- 29.5" drag radials ?
- Anybody have a pic of a clean installation of Red's Double pumper at the alternator??
- gasket set?
- Injector ID
- no volts reading on TPS
- Torque specs
- What happenes if the round seal between fuel tank and hanger is missing?
- Speedometer cable
- harland sharp roller rockers
- coil pack problem
- Directscan files I need feedback!
- starting a sitting car
- 885 lifters to 850's for quieter ?
- bl#s @ questions
- Stripping and Repainting the Intercooler
- Need ATR V-band clamp and gasket for Headers
- Oil Cooler lines
- Compression Ratio Survey
- Which Oil Pan gasket is better
- Correct key-way for Eagle crank??
- Broken Posi??? and Best Locker for our cars???
- Powermaster problems
- need help id # inj
- Red Armstrong
- Head Re-torque
- WHY ME???? no start ....
- code 13
- Bumper Fillers
- HFT Cam + Heavy springs = OK
- yes, i'm an idiot, but I fixed that prob.
- need a lil help
- Water Temp Light
- Low BLM
- translator+,lt1 maf sensor possible gone bad?
- boost just up
- Compression
- check engine light
- Polishing Rims
- AF reading with Extender Chip
- Lock up converter???
- headliner replacement
- Timing Chain Accuracy
- tuning with scanmaster
- Fuse ECM
- Tighter Steering??
- EGT Gauges
- OEM tires .
- external waste gate questions
- Fuel injector question/problem?
- oil in the intake
- Anyone try this fuel pump?
- Best place for ign. module an coil!!!
- "Here's a good one!!!" (Diagnostic)
- engine pops under boost
- Which wire do you hook up for scan master?
- question about adjusting TPS
- EGR Test
- oil leak
- Knock problems
- How does the fuel rail lose pressure?
- Tps Testing
- wire color
- Engine oils with Zinc.
- Car Won't Start After Changing Spark Plugs, What Did I Do Wrong?
- Any Advice installing Fuel Injectors ?
- pcv valve
- Cruising Driveabilty Issues
- Flywheel Bolt
- Enigine assembly (I really screwed up)
- Plenum Gasket
- Can I get a crankshaft bolt at the local parts store?
- Data Scan interpatation of readings!
- Plug wire recommendation request...and who sells them??
- CR42TS plugs causing stalling?
- TB and Plenum...
- Gauge Cluster?
- BL numbers
- codes 23 and 34 on scan master
- I want this knock GONE
- BLM's & 02's
- Front Timming Cover Replacement
- Dash Problems please help
- f/p ? need help
- Austemper 210/215 Roller Cam
- car would not start. . .
- EGR/Cruise/BLMs/etc.
- Fuel tank info needed
- Braided Oil Return Issues
- ?? on your wide band O2 installation
- How does the oe. tank vent work?
- tune up
- Headed to dragstrip tonight
- Car STILL won't charge!!
- Wheel hop with MT Drag Radials. Cant get better than 1.49 60'
- HP gains with GN1 heads
- Cam Sensor Installation
- Latest and Greatest Injector Pick?
- UPDATE on clear lenes